EOD-Detector-Simulator
About the EOD-Detector-Simulator PCB
EOD-Detector-Simulator is an open source PCB design by Neurotech-Hub, published on GitHub. It is a board, with 21 components from 13 distinct parts.
Other key parts include the OPA333xxDCK, MCP6561x-LT and INA333xxDRG. By type, the board carries 11 resistors, 6 capacitors and 3 ICs.
From the project
Spice + GUI tester
Simulate the EOD detector front-end in incremental stages, from sanity checks through passives and active blocks. Python generates waveforms, runs ngspice in batch CLI mode, parses results, and plots waveforms.
Shared models live in circuits/models/ (INA333, MCP6561 comparator, …).
Or set NGSPICE to the full path of the binary if it is not on PATH.
Run the INA333 sanity check (regression baseline):
Main components on the EOD-Detector-Simulator
EOD-Detector-Simulator bill of materials (BOM)
21 components, 13 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | OPA333xxDCK | SOT-353_SC-70-5 | U1 |
| 1 | MCP6561x-LT | SOT-353_SC-70-5 | U3 |
| 1 | INA333xxDRG | WSON-8-1EP_3x3mm_P0.5mm_EP1.45x2.4mm | U6 |
| 1 | 0-100k | 3312J-1-105E | RV1 |
| 2 | 4.7nF | C_0201_0603Metric | C2, C3 |
| 1 | 330pF | C_0201_0603Metric | C4 |
| 1 | 2.2nF | C_0201_0603Metric | C5 |
| 2 | 100nF | C_0201_0603Metric | C19, C20 |
| 4 | 1M | R_0201_0603Metric | R1, R2, R5, R15 |
| 3 | 100k | R_0201_0603Metric | R3, R4, R7 |
| 2 | 10M | R_0201_0603Metric | R6, R8 |
| 1 | 4.7k | R_0201_0603Metric | R9 |
| 1 | 22 | R_0201_0603Metric | R10 |
EOD-Detector-Simulator design files
The KiCad project lives in the Neurotech-Hub/EOD-Detector-Simulator repository on GitHub; these links point at the commit this page was built from.
- SchematicKiCad/EOD_Detector_v3-1.kicad_sch
EOD-Detector-Simulator: common questions
How many components are on the EOD-Detector-Simulator?
21 components, from 13 distinct parts. The full bill of materials is listed on this page.
Where can I download the EOD-Detector-Simulator design files?
From the Neurotech-Hub/EOD-Detector-Simulator repository on GitHub, which has the schematic; the links under Design files point to each one.
Can I use the EOD-Detector-Simulator design in my own project?
The repository has no license, so all rights stay with Neurotech-Hub. Use it as a reference, and ask the author before reusing the design.