HardLabs

Sunnypro electrical system

AhmedYehia-M23·sunnypro-electrical-system·hardware/MCU.kicad_sch

This repository ships a schematic but no board layout.

About the Sunnypro electrical system PCB

Sunnypro electrical system is an open source STM32 PCB design by AhmedYehia-M23, published on GitHub. It is a board, with 23 components from 8 distinct parts.

Its main chip is the STM32H743ZITx, from the STM32 family. By type, the board carries 17 capacitors, 1 IC, 1 connector, 1 inductor and 1 resistor.

It belongs with the sensors and robotics & motion designs in this gallery.

From the project

STM32H743 electrical architecture and KiCad schematic design for sensing, heating, motion control and protected multi-rail power.

STM32H743 · KiCad · hierarchical schematics · sensing · heating · motion control · protected multi-rail power

Electrical architecture and KiCad schematic design for an automated food-service machine developed as an HSRW group project. My scope was the electrical architecture and the electrical schematics published in this repository: MCU I/O planning, power distribution, temperature measurement, heater control, motor/encoder interfaces, load-cell measurement, actuator drivers and component selection.

Main components on the Sunnypro electrical system

STM32H743ZITx

Sunnypro electrical system bill of materials (BOM)

23 components, 8 distinct parts.

QtyPartRefs
1
STM32H743ZITx
U5
1
Conn_01x04
J2
2
2.2uF
C_VCAP1, C_VCAP2
1
FerriteBead
FB1
11
100nF
C10, C11, C12, C13, C14, C15, C17, C21 +3
4
1uF
C16, C18, C20, C23
2
10nF
C19, C24
1
10k
R6

Sunnypro electrical system design files

The KiCad project lives in the AhmedYehia-M23/sunnypro-electrical-system repository on GitHub; these links point at the commit this page was built from.

Sunnypro electrical system: common questions

What microcontroller does the Sunnypro electrical system use?

The Sunnypro electrical system is built around the STM32H743ZITx, from the STM32 family.

How many components are on the Sunnypro electrical system?

23 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Sunnypro electrical system design files?

From the AhmedYehia-M23/sunnypro-electrical-system repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the Sunnypro electrical system design in my own project?

The repository has no license, so all rights stay with AhmedYehia-M23. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Sunnypro electrical system without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards