Circuitcure2
alfred0105·circuitcure2·tests/fixtures/regulator.kicad_sch
About the Circuitcure2 PCB
Circuitcure2 is an open source PCB design by alfred0105, published on GitHub. It is a board, with 5 components from 5 distinct parts.
Other key parts include the Regulator. By type, the board carries 1 IC, 1 transistor, 1 connector, 1 capacitor and 1 resistor.
From the project
Local, lightweight AI-assisted circuit fault propagation analysis and repair prioritization.
Local, lightweight AI-assisted circuit fault propagation analysis and repair prioritization.
CircuitCare AI aims to answer a practical repair question: if one component has failed, which other components might have been affected, why, and what should be checked next?
- Synthetic fault benchmark: 10 cases / 5 topology groups; repeated runs are not independent cases. Rules exact precision .0495 and recall 1.0; LLM exact precision/recall 0; combined methods showed no exact-diagnosis gain over Rules. See Phase 17 results and Phase 17.1 correction. - PCB detector: source-provided validation…
Main components on the Circuitcure2
Circuitcure2 bill of materials (BOM)
5 components, 5 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Regulator | U1 | |
| 1 | NMOS switch | Q1 | |
| 1 | 12V Input | J1 | |
| 1 | 100uF | C1 | |
| 1 | 1k | R1 |
Circuitcure2 design files
The KiCad project lives in the alfred0105/circuitcure2 repository on GitHub; these links point at the commit this page was built from.
Circuitcure2: common questions
How many components are on the Circuitcure2?
5 components, from 5 distinct parts. The full bill of materials is listed on this page.
Where can I download the Circuitcure2 design files?
From the alfred0105/circuitcure2 repository on GitHub, which has the schematic and a netlist; the links under Design files point to each one.
Can I use the Circuitcure2 design in my own project?
The repository has no license, so all rights stay with alfred0105. Use it as a reference, and ask the author before reusing the design.