Circuitcure3

alfred0105·circuitcure3·tests/fixtures/regulator.kicad_sch

This repository ships a schematic but no board layout.

About the Circuitcure3 PCB

Circuitcure3 is an open source PCB design by alfred0105, published on GitHub. It is a board, with 5 components from 5 distinct parts.

Other key parts include the Regulator. By type, the board carries 1 IC, 1 transistor, 1 connector, 1 capacitor and 1 resistor.

From the project

Local, lightweight AI-assisted circuit fault propagation analysis and repair prioritization.

Local, lightweight AI-assisted circuit fault propagation analysis and repair prioritization.

CircuitCare AI aims to answer a practical repair question: if one component has failed, which other components might have been affected, why, and what should be checked next?

- Synthetic fault benchmark: 10 cases / 5 topology groups; repeated runs are not independent cases. Rules exact precision .0495 and recall 1.0; LLM exact precision/recall 0; combined methods showed no exact-diagnosis gain over Rules. See Phase 17 results and Phase 17.1 correction. - PCB detector: source-provided validation…

Main components on the Circuitcure3

Circuitcure3 bill of materials (BOM)

5 components, 5 distinct parts.

QtyPartRefs
1
Regulator
U1
1
NMOS switch
Q1
1
12V Input
J1
1
100uF
C1
1
1k
R1

Circuitcure3 design files

The KiCad project lives in the alfred0105/circuitcure3 repository on GitHub; these links point at the commit this page was built from.

Circuitcure3: common questions

How many components are on the Circuitcure3?

5 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the Circuitcure3 design files?

From the alfred0105/circuitcure3 repository on GitHub, which has the schematic and a netlist; the links under Design files point to each one.

Can I use the Circuitcure3 design in my own project?

The repository has no license, so all rights stay with alfred0105. Use it as a reference, and ask the author before reusing the design.