AkJtagPlusPlus
AntonKrug·akJtagPlusPlus·schematics/adapterBoard/adapterBoard.kicad_pcb
About the AkJtagPlusPlus PCB
AkJtagPlusPlus is an open source STM32 PCB design by AntonKrug, published on GitHub under the GPL-2.0 license. It is a 2-layer board measuring 48.3 × 15.2 mm, with 2 components from 2 distinct parts.
Its main chip is the STM32F429I-DISC1, from the STM32 family.
It belongs with the usb & debug tools designs in this gallery.
From the project
C++ experiments around JTAGs
Experimental JTAG dongle implemented in C++
Allowing users to interact with JTAG enabled devices with USB, or in a standalone mode with LCD (and touch screen).
Limited to only minimalistic official (vanila) JTAG specification (no custom vendor commands) and 3.3V based devices. However it's possible to convert it to different voltages, or allow level conversion to range of voltages. And adding protocols/commands is possible as well if their specification is published.
Main components on the AkJtagPlusPlus
AkJtagPlusPlus bill of materials (BOM)
2 components, 2 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | STM32F429I-DISC1 | MODULE_STM32F429I-DISC1 | U1 |
| 1 | Conn_ARM_JTAG_SWD_10 | PinHeader_2x05_P2.54mm_Vertical | JTAG1 |
AkJtagPlusPlus design files
The KiCad project lives in the AntonKrug/akJtagPlusPlus repository on GitHub; these links point at the commit this page was built from.
AkJtagPlusPlus: common questions
What microcontroller does the AkJtagPlusPlus use?
The AkJtagPlusPlus is built around the STM32F429I-DISC1, from the STM32 family.
How big is the AkJtagPlusPlus PCB?
The AkJtagPlusPlus measures 48.3 × 15.2 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the AkJtagPlusPlus?
2 components, from 2 distinct parts. The full bill of materials is listed on this page.
Where can I download the AkJtagPlusPlus design files?
From the AntonKrug/akJtagPlusPlus repository on GitHub, which has the KiCad layout; the links under Design files point to each one.
Can I use the AkJtagPlusPlus design in my own project?
Yes, under the terms of its GPL-2.0 license, which AntonKrug chose for the repository.
Can I test firmware for the AkJtagPlusPlus without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.
Similar boards
STM32
LumenPnP Motherboard
opulo-inc
149 × 95 mm296 parts4LCC-BY-SA-4.03.7kSTM32
Type g
google
169 × 30 mm24 parts2LApache-2.02.9kSTM32
Main panel
google
234 × 84 mm26 parts4LApache-2.02.9kSTM32
Base
google
52.3 × 52.3 mm36 parts2LApache-2.02.9kSTM32
Type a
google
150 × 30 mm14 parts2LApache-2.02.9kSTM32
Type c
google
188 × 30 mm17 parts2LApache-2.02.9k