Jump analyzer imu
Bugee03·jump-analyzer-imu·hardware/kicad/schematic_NO1.kicad_sch

About the Jump analyzer imu PCB
Jump analyzer imu is an open source STM32 PCB design by Bugee03, published on GitHub under the MIT license. It is a board, with 10 components from 5 distinct parts.
Its main chip is the STM32F103C8T6, from the STM32 family. Other key parts include the Load_cell. By type, the board carries 6 ICs and 4 resistors.
It belongs with the wearables and sensors designs in this gallery.
From the project
Wearable jump analyzer: STM32F103 + MPU-9250 IMU + 2x HX711 load cells (KiCad schematic)
Measures vertical jumps: flight time from a 9‑DOF IMU, take‑off / landing force from two load cells.
Flight time $t$ = time between take‑off and landing (IMU acceleration ≈ free fall, then impact spike). Jump height:
$$ h = \frac{g\,t^2}{8},\qquad g = 9.81\ \text{m/s}^2 $$
The load cells add what the IMU cannot see well: peak take‑off force, landing impact and left/right symmetry.
Main components on the Jump analyzer imu
Jump analyzer imu bill of materials (BOM)
10 components, 5 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | ~ | STM32F103C8T6 | U1 |
| 2 | Load_cell | U2, U8 | |
| 2 | ~ | HX711 | U4, U7 |
| 1 | ~ | MPU 92/65 | U6 |
| 4 | ~ | R1, R2, R3, R4 |
Jump analyzer imu design files
The KiCad project lives in the Bugee03/jump-analyzer-imu repository on GitHub; these links point at the commit this page was built from.
Jump analyzer imu: common questions
What microcontroller does the Jump analyzer imu use?
The Jump analyzer imu is built around the STM32F103C8T6, from the STM32 family.
How many components are on the Jump analyzer imu?
10 components, from 5 distinct parts. The full bill of materials is listed on this page.
Where can I download the Jump analyzer imu design files?
From the Bugee03/jump-analyzer-imu repository on GitHub, which has the schematic; the links under Design files point to each one.
Can I use the Jump analyzer imu design in my own project?
Yes, under the terms of its MIT license, which Bugee03 chose for the repository.
Can I test firmware for the Jump analyzer imu without the hardware?
Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.
Similar boards
STM32
LumenPnP Motherboard
opulo-inc
149 × 95 mm296 parts4LCC-BY-SA-4.03.7kSTM32
Main panel
google
234 × 84 mm26 parts4LApache-2.02.9kSTM32
Base
google
52.3 × 52.3 mm36 parts2LApache-2.02.9kSTM32
Type g
google
169 × 30 mm24 parts2LApache-2.02.9kSTM32
Type a
google
150 × 30 mm14 parts2LApache-2.02.9kSTM32
Type c
google
188 × 30 mm17 parts2LApache-2.02.9k