HardLabs

Rectifier

coon42·stmbl_otter·hw/kicad/rectifier2/rectifier.kicad_pcb

Rectifier PCB layout, top view — open source board by coon42
Simulate this board

About the Rectifier PCB

Rectifier is an open source PCB design by coon42, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 94 × 46 mm, with 10 components from 8 distinct parts.

By type, the board carries 3 connectors, 2 capacitors, 1 fuse and 1 diode.

It belongs with the robotics & motion and wearables designs in this gallery.

From the project

- For some reason you need exactly this compiler: gcc-arm-none-eabi-54-2016q3 - On any newer gcc version, the board does not boot after flashing !? - Adjust path in TOOLCHAIN variable in toolchain.mak** file - The board works correctly if the green LED lights up. When receiving d

- For some reason you need exactly this compiler: gcc-arm-none-eabi-54-2016q3 - On any newer gcc version, the board does not boot after flashing !? - Adjust path in TOOLCHAIN variable in toolchain.mak** file - The board works correctly if the green LED lights up. When receiving data over UART the LED flashes blue.

- Bridge pins for DFU mode while plugging in USB cable - Flash by using the following command:

Rectifier, from the project README
From the project README

Rectifier bill of materials (BOM)

10 components, 8 distinct parts.

QtyPartRefs
1
CONN_01X03
P1
1
CONN_01X02
P2
1
CONN_01X02
P3
1
Fuse
F1
2
FINDER-40.52
RL1, RL2
1
Thermistor_NTC
TH1
1
D_Bridge_-A+A
D1
2
CP
C1, C2

Rectifier design files

The KiCad project lives in the coon42/stmbl_otter repository on GitHub; these links point at the commit this page was built from.

Rectifier: common questions

How big is the Rectifier PCB?

The Rectifier measures 94 × 46 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Rectifier?

10 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Rectifier design files?

From the coon42/stmbl_otter repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Rectifier design in my own project?

Yes, under the terms of its GPL-3.0 license, which coon42 chose for the repository.

More boards in stmbl_otter

Similar boards