Termint wifi

d1aboilik·termint-wifi·kicad_board/termint-wifi.kicad_pcb

Termint wifi PCB layout, top view — open source board by d1aboilik

About the Termint wifi PCB

Termint wifi is an open source PCB design by d1aboilik, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 118.9 × 33.9 mm, with 17 components from 12 distinct parts.

By type, the board carries 6 capacitors, 3 connectors, 3 resistors, 2 transistors and 1 LED.

It belongs with the iot & wireless designs in this gallery.

From the project

This board allows the user to establish wireless low-level terminal connection by reaching an internal RS-232 header over WiFi, using ESP8266 & MAX3232.

Microcontrollers are very smart nowadays, but RS-232 ports are still a bit difficult to handle, mostly due to voltage level. Because of this, the board uses MAX3232 line driver/receiver to make the connection, and the applied ESP8266 forwards the data from UART to WiFi interface. You can find the full schematic in the KiCAD project.

Keep in mind you can only turn on MAX3232 from code, by setting GPIO5 HIGH. This prevents boot problems caused by pulling Wemos TX low too early.

Termint wifi, from the project README
From the project README

Termint wifi bill of materials (BOM)

17 components, 12 distinct parts.

QtyPartRefs
1
MMBT3904
Q1
1
AO3401A
Q2
1
Conn_01x04_Male
J1
2
Conn_01x08
J2, J3
1
LD1117S33TR_SOT223
LD1117
1
MAX3232
MAX3232
1
LED
LED1
1
10uF
C1
5
100nF
C2, C3, C4, C5, C6
1
100k
R1
1
10k
R2
1
130R
R3

Termint wifi design files

The KiCad project lives in the d1aboilik/termint-wifi repository on GitHub; these links point at the commit this page was built from.

Termint wifi: common questions

How big is the Termint wifi PCB?

The Termint wifi measures 118.9 × 33.9 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Termint wifi?

17 components, from 12 distinct parts. The full bill of materials is listed on this page.

Where can I download the Termint wifi design files?

From the d1aboilik/termint-wifi repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Termint wifi design in my own project?

Yes, under the terms of its GPL-3.0 license, which d1aboilik chose for the repository.

Similar boards