NIVA-insole-R
About the NIVA-insole-R PCB
NIVA-insole-R is an open source PCB design by https-shubhamsahu, published on GitHub. It is a 2-layer board measuring 217.5 × 234 mm, with 8 components from 8 distinct parts.
By type, the board carries 2 connectors and 1 resistor.
From the project
Bilateral gait-sensing research/screening kit with four parts:
Bilateral gait-sensing research/screening kit with four parts:
- Insole: a five-region force insole with a heel PVDF film and a protected flat tail. - Pod: worn on the lower shin (ESP32-C3, MCP3208, LSM6DSO32, removable battery cartridge, one button, one light) and controlled offline from a phone over Bluetooth. - Cartridge: a removable battery cartridge. - Dock: a desk dock that charges bare cartridges.
NIVA-insole-R bill of materials (BOM)
8 components, 8 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | CABLE TO POD J1 (JST GH 10) | WirePads_1x10_P2.0mm_LaneOrder | J1 |
| 1 | V1 PVDF FILM (signal, return) | PVDF_BondPads_2x6x2mm | J2 |
| 1 | P1 Big toe (shunt FSR, 12 mm) | FSR_Interdigitated_D12mm | FSR1 |
| 1 | P2 Medial forefoot (shunt FSR, 12 mm) | FSR_Interdigitated_D12mm | FSR2 |
| 1 | P3 Lateral forefoot (shunt FSR, 12 mm) | FSR_Interdigitated_D12mm | FSR3 |
| 1 | P4 Lateral midfoot (shunt FSR, 12 mm) | FSR_Interdigitated_D12mm | FSR4 |
| 1 | P5 Heel (shunt FSR, 12 mm) | FSR_Interdigitated_D12mm | FSR5 |
| 1 | 0603 thin film 4.7k 0.1% (right medium code) 4.7k 0.1% | R_0603_1608Metric | R1 |
NIVA-insole-R design files
The KiCad project lives in the https-shubhamsahu/niva repository on GitHub; these links point at the commit this page was built from.
NIVA-insole-R: common questions
How big is the NIVA-insole-R PCB?
The NIVA-insole-R measures 217.5 × 234 mm, has 2 copper layers and is 0.12 mm thick.
How many components are on the NIVA-insole-R?
8 components, from 8 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the NIVA-insole-R design files?
From the https-shubhamsahu/niva repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the NIVA-insole-R design in my own project?
The repository has no license, so all rights stay with https-shubhamsahu. Use it as a reference, and ask the author before reusing the design.
