HardLabs

TittaCalma

Kreyl·nute·Calmari/TittaCalma/TittaCalma.kicad_pcb

TittaCalma PCB layout, top view — open source STM32 board by Kreyl

About the TittaCalma PCB

TittaCalma is an open source STM32 PCB design by Kreyl, published on GitHub. It is a 2-layer board measuring 24.9 × 16.3 mm, with 13 components from 11 distinct parts.

Its main chip is the STM32F050K4_6, from the STM32 family. By type, the board carries 4 capacitors, 1 switch, 1 test point, 1 diode and 1 resistor.

From the project

Automatically exported from code.google.com/p/nute

TittaCalma bill of materials (BOM)

13 components, 11 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
BAT
B1
1
STM32F050K4_6
DD1
1
BUTTON
SW1
1
TESTPOINT
TP1
1
CONN_2
XL1
1
ST_SWD
XL3
1
CONN_3
XL4
1
LED
D1
3
0.1u
C1, C2, C4
1
1u
C3
1
56K
51R
R1

TittaCalma design files

The KiCad project lives in the Kreyl/nute repository on GitHub; these links point at the commit this page was built from.

TittaCalma: common questions

What microcontroller does the TittaCalma use?

The TittaCalma is built around the STM32F050K4_6, from the STM32 family.

How big is the TittaCalma PCB?

The TittaCalma measures 24.9 × 16.3 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the TittaCalma?

13 components, from 11 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the TittaCalma design files?

From the Kreyl/nute repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the TittaCalma design in my own project?

The repository has no license, so all rights stay with Kreyl. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the TittaCalma without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in nute

Similar boards