HardLabs

LED-incrementer arduino

mv805·LED-incrementer-arduino·hardware/LED-incrementer-arduino.kicad_sch

This repository ships a schematic but no board layout.

About the LED-incrementer arduino PCB

LED-incrementer arduino is an open source AVR/Arduino PCB design by mv805, published on GitHub. It is a board, with 6 components from 5 distinct parts.

Its main chip is the ABX00087, from the AVR/Arduino family. By type, the board carries 2 diodes, 2 resistors, 1 module and 1 switch.

From the project

This project is the firmware and design documentation for the LED Incrementer Arduino mechatronic assembly, part number 10029482-3.

This project is the firmware and design documentation for the LED Incrementer Arduino mechatronic assembly, part number 10029482-3.

The assembly controls a blinking LED. Pressing the increment button makes the LED blink faster by reducing the flash interval. When the minimum interval is reached, the next button press wraps the interval back to the maximum. The current interval is shown on the Arduino Uno R4 WiFi LED matrix, and a status LED indicates when the button is pressed.

Main components on the LED-incrementer arduino

ABX00087

LED-incrementer arduino bill of materials (BOM)

6 components, 5 distinct parts.

QtyPartRefs
1
ABX00087
Arduino_Uno_R4_WiFi
A1
1
B3F-1000
SW_Push_Button
SW1
1
LED_RED
D1
1
LED_BLUE
D2
2
470
R1, R2

LED-incrementer arduino design files

The KiCad project lives in the mv805/LED-incrementer-arduino repository on GitHub; these links point at the commit this page was built from.

LED-incrementer arduino: common questions

What microcontroller does the LED-incrementer arduino use?

The LED-incrementer arduino is built around the ABX00087, from the AVR/Arduino family.

How many components are on the LED-incrementer arduino?

6 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the LED-incrementer arduino design files?

From the mv805/LED-incrementer-arduino repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the LED-incrementer arduino design in my own project?

The repository has no license, so all rights stay with mv805. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the LED-incrementer arduino without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards