Rj45-mapper

rixnobis·rj45-mapper

Rj45-mapper PCB layout, top view — open source board by rixnobis

About the Rj45-mapper PCB

Rj45-mapper is an open source PCB design by rixnobis, published on GitHub. It is a 2-layer board measuring 75 × 50 mm, with 24 components from 7 distinct parts.

Other key parts include the ULN2803A. By type, the board carries 12 resistors, 9 diodes, 2 connectors and 1 IC.

From the project

RJ45 cable pin mapper: touch a flying wire to the pad, the LED for its 8P8C pin lights

A bench probe for unknown cables that have an 8P8C (RJ45) plug on one end and loose wires on the other. Plug the cable into the jack and touch one loose wire to the pad. The LED for the jack pin that wire lands on lights up. If two pins are shorted together in the cable, two LEDs light.

The pad sits at 5 V through 1k. Each jack pin drives one input of a ULN2803A, and each ULN output sinks one red LED through 330R (about 7 mA). A wire grounded at its far end draws 5 mA from the pad, so it is not a short. A finger across the pad and a wire (around 1 Mohm) puts the input under 0.1 V, far below…

Rj45-mapper, from the project README
From the project README

Main components on the Rj45-mapper

Rj45-mapper bill of materials (BOM)

24 components, 7 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
ULN2803A
U1
1
TE 5555164-1 or equal, RA unshielded
J1
1
USB-C_5V
J2
9
C84270
RED
D1, D2, D3, D4, D5, D6, D7, D8 +1
8
330
R1, R2, R3, R4, R5, R6, R7, R8
2
1k
R9, R10
2
5.1K
5.1k
R11, R12

Rj45-mapper design files

The KiCad project lives in the rixnobis/rj45-mapper repository on GitHub; these links point at the commit this page was built from.

Rj45-mapper: common questions

How big is the Rj45-mapper PCB?

The Rj45-mapper measures 75 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Rj45-mapper?

24 components, from 7 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Rj45-mapper design files?

From the rixnobis/rj45-mapper repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Rj45-mapper design in my own project?

The repository has no license, so all rights stay with rixnobis. Use it as a reference, and ask the author before reusing the design.