Buck-Converter

Abhi90808·Buck-Converter

Buck-Converter PCB layout, top view — open source STM32 board by Abhi90808

About the Buck-Converter PCB

Buck-Converter is an open source STM32 PCB design by Abhi90808, published on GitHub. It is a 2-layer board measuring 49.2 × 63.6 mm, with 33 components from 16 distinct parts.

Its main chip is the STM32L051C8T6, from the STM32 family. Other key parts include the TP4056 and AMS1117-3.3. By type, the board carries 18 capacitors, 5 connectors, 5 resistors, 3 ICs, 1 crystal and 1 switch.

It belongs with the power & battery and rf & radio designs in this gallery.

From the project

High-efficiency DC-DC step-down buck converter PCB with adjustable output voltage, designed for regulated power supply applications.

A high-efficiency DC-DC step-down (buck) converter PCB designed in KiCad 8. Converts a higher DC input voltage to a lower regulated DC output, suitable for embedded systems and power supply applications.

The LM2596 switches at 150kHz, driving current through an inductor. The LC output filter averages the switched waveform into steady DC. A feedback resistor divider compares the output to the IC's internal 1.23V reference to regulate the output voltage.

Main components on the Buck-Converter

Buck-Converter bill of materials (BOM)

33 components, 16 distinct parts.

QtyPartRefs
1
TP4056
U1
1
AMS1117-3.3
U2
1
STM32L051C8T6
U3
1
32.768kHz
Y1
1
USB_C
J1
1
BATTERY
J2
1
NEO6M_GPS
J3
1
SX1276_LORA
J4
1
SWD_DEBUG
J5
1
RESET
SW1
5
10uf
C1, C3, C5, C7, C11
8
100nf
C2, C4, C6, C8, C9, C10, C12, C15
5
12pf
C13, C14, C16, C17, C18
2
5.1k
R1, R2
1
1.2k
R3
2
10k
R4, R5

Buck-Converter design files

The KiCad project lives in the Abhi90808/Buck-Converter repository on GitHub; these links point at the commit this page was built from.

Buck-Converter: common questions

What microcontroller does the Buck-Converter use?

The Buck-Converter is built around the STM32L051C8T6, from the STM32 family.

How big is the Buck-Converter PCB?

The Buck-Converter measures 49.2 × 63.6 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Buck-Converter?

33 components, from 16 distinct parts. The full bill of materials is listed on this page.

Where can I download the Buck-Converter design files?

From the Abhi90808/Buck-Converter repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Buck-Converter design in my own project?

The repository has no license, so all rights stay with Abhi90808. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Buck-Converter without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards