Connector
About the Connector PCB
Connector is an open source PCB design by ADVecu, published on GitHub. It is a 2-layer board measuring 44.8 × 43.8 mm, with 3 components from 2 distinct parts.
From the project
ADV.dash is a dashboard project built with LVGL and ESP32-S3. It is prepared to receive CAN bus data from rusEFI and, in the future, other programmable ECUs.
ADV.dash is a dashboard project built with LVGL and ESP32-S3. It is prepared to receive CAN bus data from rusEFI and, in the future, other programmable ECUs.
2. Open the project in PlatformIO. 3. Copy the file esp32-s3-devkitc-1-5inch to the boards directory of the Espressif platform in PlatformIO. 4. Copy lvconf.h` to its correct LVGL configuration folder. 5. Build and upload the project to your ESP32-S3.
Connector bill of materials (BOM)
3 components, 2 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | 776276-1 | 7762761 | J1 |
| 2 | 2.54mm 1x4 | PinHeader_1x04_P2.54mm_Vertical | J2, J3 |
Connector design files
The KiCad project lives in the ADVecu/ADV.dash repository on GitHub; these links point at the commit this page was built from.
Connector: common questions
How big is the Connector PCB?
The Connector measures 44.8 × 43.8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Connector?
3 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the Connector design files?
From the ADVecu/ADV.dash repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the Connector design in my own project?
The repository has no license, so all rights stay with ADVecu. Use it as a reference, and ask the author before reusing the design.
