Stm32-usb uart i2c swd

anilv8·stm32-usb-uart-i2c-swd

Stm32-usb uart i2c swd PCB layout, top view — open source STM32 board by anilv8

About the Stm32-usb uart i2c swd PCB

Stm32-usb uart i2c swd is an open source STM32 PCB design by anilv8, published on GitHub. It is a 2-layer board measuring 42 × 30 mm, with 28 components from 16 distinct parts.

Its main chip is the STM32F103C8T6, from the STM32 family. Other key parts include the AMS1117-3.3. By type, the board carries 13 capacitors, 5 resistors, 4 connectors, 2 ICs, 1 crystal and 1 switch.

From the project

STM32 board with USB, I2C, UART, SWD

Main components on the Stm32-usb uart i2c swd

Stm32-usb uart i2c swd bill of materials (BOM)

28 components, 16 distinct parts.

QtyPartRefs
1
STM32F103C8T6
U1
1
AMS1117-3.3
U2
1
16MHz
Y1
1
USB_B_Micro
J1
3
Conn_01x04_Pin
J2, J3, J4
1
SW_SPDT
SW1
1
RED
D1
1
120R
FB1
5
100n
C1, C2, C3, C4, C9
1
10u
C5
1
10n
C6
2
1u
C7, C8
2
10p
C10, C11
2
22u
C12, C13
1
10k
R1
4
1k5
R2, R3, R4, R5

Stm32-usb uart i2c swd design files

The KiCad project lives in the anilv8/stm32-usb-uart-i2c-swd repository on GitHub; these links point at the commit this page was built from.

Stm32-usb uart i2c swd: common questions

What microcontroller does the Stm32-usb uart i2c swd use?

The Stm32-usb uart i2c swd is built around the STM32F103C8T6, from the STM32 family.

How big is the Stm32-usb uart i2c swd PCB?

The Stm32-usb uart i2c swd measures 42 × 30 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Stm32-usb uart i2c swd?

28 components, from 16 distinct parts. The full bill of materials is listed on this page.

Where can I download the Stm32-usb uart i2c swd design files?

From the anilv8/stm32-usb-uart-i2c-swd repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Stm32-usb uart i2c swd design in my own project?

The repository has no license, so all rights stay with anilv8. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Stm32-usb uart i2c swd without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards