Parallel nor csp56

azonenberg·dumptruck·dut-breakouts/parallel-nor-csp56/parallel-nor-csp56.kicad_pcb

Parallel nor csp56 PCB layout, top view — open source board by azonenberg

About the Parallel nor csp56 PCB

Parallel nor csp56 is an open source PCB design by azonenberg, published on GitHub under the BSD-3-Clause license. It is a 4-layer board measuring 57 × 31 mm, with 10 components from 8 distinct parts.

Other key parts include the MX29GL512FLXGI and M24C02-RMC6TG. By type, the board carries 4 resistors, 3 capacitors, 2 ICs and 1 connector.

From the project

FPGA based dumper for flashes and more

1.0V shunt resistor is missing a zone fill. Will monitor droop under load and see if we need to add top layer power path. U33 is way too close to J10. Seems to have fit OK, not touching for now, but tough to assemble. INITB and PROGB on FPGA are 1.8V signals but we try to drive with 3.3 from supervisor! Rework: add pull to 1.8V on board, open drain in super firmware JTAG connector VCC is connected to 3.3V. We need to supply 1.8 here. Temporary workaround: six pin extension cable, pass through JTAG + GND and supply 1.8V to dongle externally. Long term fix: interposer board * DONE on FPGA is…

Main components on the Parallel nor csp56

MX29GL512FLXGIM24C02-RMC6TG

Parallel nor csp56 bill of materials (BOM)

10 components, 8 distinct parts.

Qty	Part	Footprint	Refs
1	MX29GL512FLXGI	BGA_56_6x9_DEPOP_0.8MM_CFI_CSP	U1
1	M24C02-RMC6TG	DFN_8_0.5MM_2x3MM_TALL	U2
1	CONN_DUMPTRUCK_DEVICE	CONN_SAMTEC_BSE-040-01-L-D-A-TR	J1
2	0.47 uF	EIA_0402_CAP_NOSILK	C1, C3
1	4.7 uF	EIA_0603_CAP_NOSILK	C2
1	0	EIA_0402_RES_NOSILK	R1
1	1K	EIA_0402_RES_NOSILK	R2
2	10K	EIA_0402_RES_NOSILK	R3, R4

Parallel nor csp56 design files

The KiCad project lives in the azonenberg/dumptruck repository on GitHub; these links point at the commit this page was built from.

Parallel nor csp56: common questions

How big is the Parallel nor csp56 PCB?

The Parallel nor csp56 measures 57 × 31 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Parallel nor csp56?

10 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Parallel nor csp56 design files?

From the azonenberg/dumptruck repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Parallel nor csp56 design in my own project?

Yes, under the terms of its BSD-3-Clause license, which azonenberg chose for the repository.

More boards in dumptruck