HardLabs

Sdvx

bass9030·sdvx-controller-project·main-pcb/sdvx.kicad_pcb

Sdvx PCB layout, top view — open source AVR/Arduino board by bass9030

About the Sdvx PCB

Sdvx is an open source AVR/Arduino PCB design by bass9030, published on GitHub. It is a 2-layer board measuring 42 × 65 mm, with 15 components from 5 distinct parts.

Its main chip is the Teensy2.0_(Arduino), from the AVR/Arduino family. By type, the board carries 6 resistors, 4 battery holders and 1 IC.

From the project

making controller for sdvx

Main components on the Sdvx

Teensy2.0_(Arduino)

Sdvx bill of materials (BOM)

15 components, 5 distinct parts.

QtyPartRefs
1
Teensy2.0_(Arduino)
U1
4
Conn_01x02
BT-A1, BT-B1, BT-C1, BT-D1
2
Conn_01x02
FX-L1, FX-R1
2
Conn_01x04
VOL-L1, VOL-R1
6
10k
R1, R2, R3, R4, R5, R6

Sdvx design files

The KiCad project lives in the bass9030/sdvx-controller-project repository on GitHub; these links point at the commit this page was built from.

Sdvx: common questions

What microcontroller does the Sdvx use?

The Sdvx is built around the Teensy2.0_(Arduino), from the AVR/Arduino family.

How big is the Sdvx PCB?

The Sdvx measures 42 × 65 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Sdvx?

15 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the Sdvx design files?

From the bass9030/sdvx-controller-project repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Sdvx design in my own project?

The repository has no license, so all rights stay with bass9030. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Sdvx without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in sdvx-controller-project

Similar boards