HardLabs

Knit yarn badge v4 rgb

borisnimcevic·knit_yarn·knit_yarn_badge_v4_rgb/knit_yarn_badge_v4_rgb.kicad_pcb

Knit yarn badge v4 rgb PCB layout, top view — open source board by borisnimcevic

About the Knit yarn badge v4 rgb PCB

Knit yarn badge v4 rgb is an open source PCB design by borisnimcevic, published on GitHub. It is a 2-layer board measuring 33.8 × 36.1 mm, with 14 components from 4 distinct parts.

By type, the board carries 6 diodes, 6 resistors, 1 battery holder and 1 switch.

It belongs with the wearables designs in this gallery.

From the project

A round PCB badge shaped like a ball of yarn with knitting needles. Six LEDs shine through the board face-down, lighting up the design from behind. Powered by a CR2032 coin cell; the brooch pin doubles as the power switch.

A round PCB badge shaped like a ball of yarn with knitting needles. Six LEDs shine through the board face-down, lighting up the design from behind. Powered by a CR2032 coin cell; the brooch pin doubles as the power switch.

Designed in KiCad. Three badge variants and one SAO variant are included.

Ready-to-order Gerber zips are in the order/ folder:

- order/knityarnbadgev1.zip - order/knityarnbadgev2.zip - order/knityarnbadgev3.zip ← recommended - order/knityarnSAO.zip`

Knit yarn badge v4 rgb, from the project README
From the project README

Knit yarn badge v4 rgb bill of materials (BOM)

14 components, 4 distinct parts.

QtyPartRefs
1
Battery_Cell
BT1
1
SW_SPST
SW1
6
LED
D1, D2, D3, D4, D5, D6
6
TBD
R1, R2, R3, R4, R5, R6

Knit yarn badge v4 rgb design files

The KiCad project lives in the borisnimcevic/knit_yarn repository on GitHub; these links point at the commit this page was built from.

Knit yarn badge v4 rgb: common questions

How big is the Knit yarn badge v4 rgb PCB?

The Knit yarn badge v4 rgb measures 33.8 × 36.1 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Knit yarn badge v4 rgb?

14 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the Knit yarn badge v4 rgb design files?

From the borisnimcevic/knit_yarn repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Knit yarn badge v4 rgb design in my own project?

The repository has no license, so all rights stay with borisnimcevic. Use it as a reference, and ask the author before reusing the design.

More boards in knit_yarn

Similar boards