HardLabs

STM32-HW-Design with

CagriCatik·STM32-HW-Design-with-KiCAD·stm32_prototype/stm32_prototype.kicad_sch

This repository ships a schematic but no board layout.

About the STM32-HW-Design with PCB

STM32-HW-Design with is an open source STM32 PCB design by CagriCatik, published on GitHub. It is a board, with 16 components from 10 distinct parts.

Its main chip is the STM32F103C8Tx, from the STM32 family. By type, the board carries 11 capacitors, 1 IC, 1 crystal, 1 switch, 1 inductor and 1 resistor.

From the project

PCB design journey using KiCad and an STM32 microcontroller

The goal was not only to learn KiCad as a professional tool, but to understand what makes a microcontroller board electrically reliable, layout-aware, and production-ready. Every stage reflects actual engineering constraints encountered during the design of a small STM32-based board.

- [X] STM32 microcontroller fundamentals and decoupling guidance. - [X] STM32 configuration pin requirements and best practices. - [ ] Pin-out management using STM32CubeIDE. - [ ] Crystal oscillator circuit design. - [ ] USB interface design for STM32 systems. - [ ] Power supply design and connector selection. -…

Main components on the STM32-HW-Design with

STM32F103C8Tx

STM32-HW-Design with bill of materials (BOM)

16 components, 10 distinct parts.

QtyPartRefs
1
STM32F103C8Tx
U1
1
16Mhz
Y1
1
SW_SPDT
SW1
1
120R
FB1
4
100n
C1, C2, C3, C4
2
10n
C5, C6
2
1u
C7, C8
1
100u
C9
2
10p
C10, C11
1
R
R1

STM32-HW-Design with design files

The KiCad project lives in the CagriCatik/STM32-HW-Design-with-KiCAD repository on GitHub; these links point at the commit this page was built from.

STM32-HW-Design with: common questions

What microcontroller does the STM32-HW-Design with use?

The STM32-HW-Design with is built around the STM32F103C8Tx, from the STM32 family.

How many components are on the STM32-HW-Design with?

16 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the STM32-HW-Design with design files?

From the CagriCatik/STM32-HW-Design-with-KiCAD repository on GitHub, which has the schematic; the links under Design files point to each one.

Can I use the STM32-HW-Design with design in my own project?

The repository has no license, so all rights stay with CagriCatik. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the STM32-HW-Design with without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards