HardLabs

Eyescontrol

cdrfiuba·marciano·pcbs/eyescontrol/eyescontrol.kicad_pcb

Eyescontrol PCB layout, top view — open source AVR/Arduino board by cdrfiuba

About the Eyescontrol PCB

Eyescontrol is an open source AVR/Arduino PCB design by cdrfiuba, published on GitHub. It is a 2-layer board measuring 40.6 × 43.2 mm, with 13 components from 10 distinct parts.

Its main chip is the ATMEGA88-P, from the AVR/Arduino family. By type, the board carries 6 capacitors, 3 connectors, 1 IC, 1 crystal, 1 switch and 1 resistor.

Main components on the Eyescontrol

ATMEGA88-P

Eyescontrol bill of materials (BOM)

13 components, 10 distinct parts.

QtyPartRefs
1
ATMEGA88-P
IC1
1
18.432 MHz
Y1
1
EYES
P1
1
PROG_MICRO
P2
1
CONN_01X04
P3
1
SW_PUSH
SW1
3
100n
C1, C2, C4
2
15p
C3, C5
1
330u
C6
1
10k
R1

Eyescontrol design files

The KiCad project lives in the cdrfiuba/marciano repository on GitHub; these links point at the commit this page was built from.

Eyescontrol: common questions

What microcontroller does the Eyescontrol use?

The Eyescontrol is built around the ATMEGA88-P, from the AVR/Arduino family.

How big is the Eyescontrol PCB?

The Eyescontrol measures 40.6 × 43.2 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Eyescontrol?

13 components, from 10 distinct parts. The full bill of materials is listed on this page.

Where can I download the Eyescontrol design files?

From the cdrfiuba/marciano repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Eyescontrol design in my own project?

The repository has no license, so all rights stay with cdrfiuba. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Eyescontrol without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in marciano

Similar boards