Carrier 2cell
About the Carrier 2cell PCB
Carrier 2cell is an open source PCB design by DashiellRussell, published on GitHub. It is a 2-layer board measuring 111.5 × 47.8 mm, with 3 components from 2 distinct parts.
By type, the board carries 2 connectors and 1 battery holder.
It belongs with the dev boards & breakouts designs in this gallery.
From the project
18650 cell carrier PCBs (1/2/3/4 cell) - per-cell breakout to solder pads and a combined screw/Micro-Fit output. V01.0
A family of four single-purpose PCBs that hold 18650 cells and break every cell out independently. No BMS, no protection, no series or parallel wiring in copper — these are dumb carriers. All the intelligence, and all the linking, lives in whatever you wire onto them.
Each board is its own KiCad project in its own folder, sharing one library in libs/ — the same layout convention as AURCBMS. Board height is the width of the cell holders plus a 4.0 mm margin per side, which is the smallest margin that leaves room for an M3 keep-out at the corners next to a connector; the generator solves for…
Carrier 2cell bill of materials (BOM)
3 components, 2 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 2 | Screw5.00_or_MicroFit3.0 | PowerOut_Screw5.00_or_MicroFit3.00_RA | J1, J2 |
| 1 | BH-18650-B6AA007 MYOUNG(美阳) | BAT-SMD_L77.0-W39.8_BH-18650-B6AA007 | BT1 |
Carrier 2cell design files
The KiCad project lives in the DashiellRussell/18650-cell-carriers repository on GitHub; these links point at the commit this page was built from.
Carrier 2cell: common questions
How big is the Carrier 2cell PCB?
The Carrier 2cell measures 111.5 × 47.8 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Carrier 2cell?
3 components, from 2 distinct parts. The full bill of materials is listed on this page.
Where can I download the Carrier 2cell design files?
From the DashiellRussell/18650-cell-carriers repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the Carrier 2cell design in my own project?
The repository has no license, so all rights stay with DashiellRussell. Use it as a reference, and ask the author before reusing the design.
More boards in 18650-cell-carriers
Similar boards
88 Pin Vag Breakout
rusefi
142 × 58 mm91 parts2LGPL-3.01.2k
134pin 7-967288-1
139.7 × 73.7 mm38 parts2LGPL-3.01.2k
Breakout 60pin EEC-IV
139.7 × 62.2 mm15 parts2LGPL-3.01.2k
Breakout 112pin Connector
174 × 58 mm39 parts2LGPL-3.01.2k
Eecv breakout
140.8 × 53.7 mm9 parts4LGPL-3.01.2k
Rj45 breakout
rene-dev
15.2 × 53.8 mm3 parts2LGPL-3.0979