EvokeFlowDisplay

davidmpye·EvokeFlowDisplay·pcb/nt7538/evoke.kicad_pcb

EvokeFlowDisplay PCB layout, top view — open source STM32 board by davidmpye

About the EvokeFlowDisplay PCB

EvokeFlowDisplay is an open source STM32 PCB design by davidmpye, published on GitHub. It is a 2-layer board measuring 60 × 45 mm, with 28 components from 13 distinct parts.

Its main chip is the GD32E230C8T6, from the STM32 family. By type, the board carries 19 capacitors, 4 resistors, 2 connectors, 1 IC and 1 transistor.

It belongs with the displays & leds designs in this gallery.

From the project

Hardware and software for an LCD or OLED screen adaptor for Pure Evoke Flow and F4 radios

Main components on the EvokeFlowDisplay

GD32E230C8T6

EvokeFlowDisplay bill of materials (BOM)

28 components, 13 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
GD32E230C8T6
STM32F103C8Tx
U1
1
Q_NMOS_GSD
Q1
1
CONN_01X03_MALE
Conn_01x03_Male
J1
1
BACKLIGHT_CONN
J2
1
Conn_01x05
ST_LINK1
9
1UF
1uF
C1, C10, C11, C14, C15, C16, C17, C18 +1
1
10UF
10uF
C2
2
C
C3, C4
6
100NF
100nF
C5, C6, C7, C8, C9, C12
1
4.7UF
4.7uF
C13
2
10K
R1, R3
1
500R
R2
1
200K
R4

EvokeFlowDisplay design files

The KiCad project lives in the davidmpye/EvokeFlowDisplay repository on GitHub; these links point at the commit this page was built from.

EvokeFlowDisplay: common questions

What microcontroller does the EvokeFlowDisplay use?

The EvokeFlowDisplay is built around the GD32E230C8T6, from the STM32 family.

How big is the EvokeFlowDisplay PCB?

The EvokeFlowDisplay measures 60 × 45 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the EvokeFlowDisplay?

28 components, from 13 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the EvokeFlowDisplay design files?

From the davidmpye/EvokeFlowDisplay repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the EvokeFlowDisplay design in my own project?

The repository has no license, so all rights stay with davidmpye. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the EvokeFlowDisplay without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards