HardLabs

Slice PRTO SMT S2L

feastorg·Slice_PRTO_SMT_S2L·hardware/BREAD_Slice.kicad_pcb

Slice PRTO SMT S2L PCB layout, top view — open source AVR/Arduino board by feastorg

About the Slice PRTO SMT S2L PCB

Slice PRTO SMT S2L is an open source AVR/Arduino PCB design by feastorg, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 70 × 100 mm, with 10 components from 8 distinct parts.

Its main chip is the Arduino_Nano_v3.x, from the AVR/Arduino family. By type, the board carries 4 capacitors, 1 IC, 1 module, 1 connector, 1 diode and 1 inductor.

From the project

Prototyping Slice for Rapidly Creating BREAD Devices.

BREAD slice for creating new BREAD slices.

[Explain how to use the project. Include examples and screenshots if applicable.]

Main components on the Slice PRTO SMT S2L

Arduino_Nano_v3.x

Slice PRTO SMT S2L bill of materials (BOM)

10 components, 8 distinct parts.

QtyPartRefs
1
~
U1
1
Arduino_Nano_v3.x
A1
1
Conn_01x10_Female
J1
1
Heatsink_Pad
HS1
1
WS2812B_5050
D1
1
4.7uH
L1
3
22uF
C1, C3, C4
1
100nF
C2

Slice PRTO SMT S2L design files

The KiCad project lives in the feastorg/Slice_PRTO_SMT_S2L repository on GitHub; these links point at the commit this page was built from.

Slice PRTO SMT S2L: common questions

What microcontroller does the Slice PRTO SMT S2L use?

The Slice PRTO SMT S2L is built around the Arduino_Nano_v3.x, from the AVR/Arduino family.

How big is the Slice PRTO SMT S2L PCB?

The Slice PRTO SMT S2L measures 70 × 100 mm, has 2 copper layers and is 1.67 mm thick.

How many components are on the Slice PRTO SMT S2L?

10 components, from 8 distinct parts. The full bill of materials is listed on this page.

Where can I download the Slice PRTO SMT S2L design files?

From the feastorg/Slice_PRTO_SMT_S2L repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Slice PRTO SMT S2L design in my own project?

Yes, under the terms of its GPL-3.0 license, which feastorg chose for the repository.

Can I test firmware for the Slice PRTO SMT S2L without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards