The pit

gcask·the-pit·hardware/daisy_hc165/daisy_hc165.kicad_pcb

The pit PCB layout, top view — open source board by gcask

About the The pit PCB

The pit is an open source PCB design by gcask, published on GitHub under the MPL-2.0 license. It is a 2-layer board measuring 44 × 55 mm, with 8 components from 6 distinct parts.

Other key parts include the 74HC165. By type, the board carries 4 connectors, 2 resistors, 1 IC and 1 capacitor.

From the project

Flexible gamepad system with an arduino-based SPI hc165 daisy-chain

Simple arduino-based gamepad to connect custom switches and toggles and easily bind into DCS (uses standard mappings, nothing fancy).

Supports hundreds of switches on a single arduino board.

Relies on HC165N Parallel-Load Shift Registers, which are inexpensive ICs, to achieve a high number of inputs.

Arduino-based program to manage a Sim Pit efficiently. The code is setup to be able to handle hundreds of inputs over a single Arduino chip, via the use of shift registers and SPI.

The pit, from the project README
From the project README

Main components on the The pit

The pit bill of materials (BOM)

8 components, 6 distinct parts.

QtyPartRefs
1
74HC165
U1
2
Conn_01x05_Male
J1, J2
1
DaisyChain_In
J3
1
DaisyChain_Out
J4
1
C1525
100nF
C1
2
C29718
10k
RN1, RN2

The pit design files

The KiCad project lives in the gcask/the-pit repository on GitHub; these links point at the commit this page was built from.

The pit: common questions

How big is the The pit PCB?

The The pit measures 44 × 55 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the The pit?

8 components, from 6 distinct parts. The full bill of materials is listed on this page.

Where can I download the The pit design files?

From the gcask/the-pit repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the The pit design in my own project?

Yes, under the terms of its MPL-2.0 license, which gcask chose for the repository.