Wifi oscilloscope 001

gravitymir·wifi_oscilloscope_001

Wifi oscilloscope 001 PCB layout, top view — open source board by gravitymir

About the Wifi oscilloscope 001 PCB

Wifi oscilloscope 001 is an open source PCB design by gravitymir, published on GitHub under the MIT license. It is a 2-layer board measuring 57 × 29 mm, with 14 components from 9 distinct parts.

Other key parts include the AD7476 and MCP6022. By type, the board carries 4 connectors, 4 capacitors, 3 resistors, 2 ICs and 1 diode.

It belongs with the iot & wireless and test & measurement designs in this gallery.

From the project

oscilloscope ESP32

Компактный одноканальный безэкранный WiFi-осциллограф для авто-диагностики. Щуп оцифровывает сигнал и стримит отсчёты по WiFi на ПК. Эта плата — низкочастотный прецизионный аналоговый фронт-энд (суб-МГц): ESP32-S3 читает внешний АЦП AD7476 по SPI и отправляет данные по WiFi.

- AC-связь (C3) убирает постоянную составляющую входного сигнала. - Делитель R1/R2 смещает сигнал в середину шкалы АЦП (~1.65 В при питании 3.3 В). - U2A (операционник MCP6022) — буфер с единичным усилением: развязывает высокоомный делитель от входа АЦП. Обратная связь: выход(1) → −вход(2); выход → R3 → AIN. - D1…

Main components on the Wifi oscilloscope 001

AD7476MCP6022

Wifi oscilloscope 001 bill of materials (BOM)

14 components, 9 distinct parts.

QtyPartRefs
1
AD7476
U1
1
MCP6022
U2
2
Conn_01x09
J1, J2
2
Conn_01x01
J3, J4
1
BAT54S
D1
2
1u
C1, C3
2
100n
C2, C5
2
100k
R1, R2
1
100
R3

Wifi oscilloscope 001 design files

The KiCad project lives in the gravitymir/wifi_oscilloscope_001 repository on GitHub; these links point at the commit this page was built from.

Wifi oscilloscope 001: common questions

How big is the Wifi oscilloscope 001 PCB?

The Wifi oscilloscope 001 measures 57 × 29 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Wifi oscilloscope 001?

14 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Wifi oscilloscope 001 design files?

From the gravitymir/wifi_oscilloscope_001 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Wifi oscilloscope 001 design in my own project?

Yes, under the terms of its MIT license, which gravitymir chose for the repository.

Similar boards