LCC Interface

honzup·LCC_Interface_KiCad

LCC Interface PCB layout, top view — open source board by honzup

About the LCC Interface PCB

LCC Interface is an open source PCB design by honzup, published on GitHub under the CERN-OHL-P-2.0 license. It is a 2-layer board measuring 60 × 50 mm, with 17 components from 11 distinct parts.

Other key parts include the TCAN332DR. By type, the board carries 6 resistors, 4 diodes, 3 connectors, 2 capacitors, 1 IC and 1 jumper.

From the project

LCC/OpenLCB CAN interface board (KiCad): TCAN332, dual RJ45, termination jumper, test points, LEDs (mirror of Forgejo)

A small two-layer board that connects any 3.3 V microcontroller with a CAN controller (ESP32 TWAI, STM32, …) to an LCC / OpenLCB bus using standard RJ45 cables. Designed in KiCad for model railway layouts; in daily use on my layout under every LCC node and the Ethernet bridge (lcc-eth-bridge).

Why a dedicated board rather than a ready-made transceiver module:

LCC Interface, from the project README
From the project README

Main components on the LCC Interface

LCC Interface bill of materials (BOM)

17 components, 11 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
TCAN332DR
U1
2
LCC RJ45
J1, J2
1
MCU INTERFACE
J3
1
TERM ENABLE
JP1
1
PESD1CAN
D1
3
LED
D2, D3, D4
1
100nF
C1
1
4.7uF
C2
1
120R
R1
2
10K
10k DNP
R2, R3
3
1k
R4, R5, R6

LCC Interface design files

The KiCad project lives in the honzup/LCC_Interface_KiCad repository on GitHub; these links point at the commit this page was built from.

LCC Interface: common questions

How big is the LCC Interface PCB?

The LCC Interface measures 60 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the LCC Interface?

17 components, from 11 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the LCC Interface design files?

From the honzup/LCC_Interface_KiCad repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the LCC Interface design in my own project?

Yes, under the terms of its CERN-OHL-P-2.0 license, which honzup chose for the repository.