HardLabs

Lab1

HTheolin·pasc·Labs/Hardware/Lab1/Lab1.kicad_pcb

Lab1 PCB layout, top view — open source STM32 board by HTheolin

About the Lab1 PCB

Lab1 is an open source STM32 PCB design by HTheolin, published on GitHub. It is a 2-layer board measuring 40 × 40 mm, with 25 components from 13 distinct parts.

Its main chip is the STM32F411RETx, from the STM32 family. Other key parts include the LM1117ADJ. By type, the board carries 16 capacitors, 4 resistors, 2 ICs, 2 connectors and 1 crystal.

Main components on the Lab1

LM1117ADJSTM32F411RETx

Lab1 bill of materials (BOM)

25 components, 13 distinct parts.

QtyPartRefs
1
LM1117ADJ
U1
1
STM32F411RETx
U2
1
8.0MHz
Y1
1
USB_OTG
J1
1
Conn_01x06_Male
J2
9
100n
C1, C4, C7, C8, C9, C11, C12, C13 +1
2
18p
C2, C5
2
10u
C3, C16
2
4.7u
C6, C14
1
1u
C10
2
10k
R1, R2
1
3,3k
R3
1
5,6k
R4

Lab1 design files

The KiCad project lives in the HTheolin/pasc repository on GitHub; these links point at the commit this page was built from.

Lab1: common questions

What microcontroller does the Lab1 use?

The Lab1 is built around the STM32F411RETx, from the STM32 family.

How big is the Lab1 PCB?

The Lab1 measures 40 × 40 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Lab1?

25 components, from 13 distinct parts. The full bill of materials is listed on this page.

Where can I download the Lab1 design files?

From the HTheolin/pasc repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Lab1 design in my own project?

The repository has no license, so all rights stay with HTheolin. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Lab1 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in pasc

Similar boards