Arms Length

husnainxali·Arms_Length·PCB/Arms_length.kicad_pcb

Arms Length PCB layout, top view — open source AVR/Arduino board by husnainxali

About the Arms Length PCB

Arms Length is an open source AVR/Arduino PCB design by husnainxali, published on GitHub under the MIT license. It is a 2-layer board measuring 35.6 × 59.8 mm, with 5 components from 5 distinct parts.

Its main chip is the Arduino_Nano_v3.x, from the AVR/Arduino family. Other key parts include the HC-SR04. By type, the board carries 1 IC, 1 module, 1 buzzer, 1 diode and 1 resistor.

From the project

A device that measures the distance between u and your monitor when u get too close to your monitor it starts buzzing.

I made this because i have a bad habit that i get my face too close to my monitor and it has affected my eyesight, So as a solution i made this and now device starts buzzing when i get close to the monitor and a red led lights up.

I used kicad to design the PCB from scratch, all the files are available in PCB Folder.

I modelled the case for the device in Autodesk Fusion, Files are available in 3Dmodels folder and Production Folder.

Arms Length, from the project README
From the project README

Main components on the Arms Length

Arms Length bill of materials (BOM)

5 components, 5 distinct parts.

QtyPartRefs
1
HC-SR04
Universal Microelectronics
U1
1
Arduino_Nano_v3.x
A1
1
Buzzer
BZ1
1
LED
D1
1
R
R1

Arms Length design files

The KiCad project lives in the husnainxali/Arms_Length repository on GitHub; these links point at the commit this page was built from.

Arms Length: common questions

What microcontroller does the Arms Length use?

The Arms Length is built around the Arduino_Nano_v3.x, from the AVR/Arduino family.

How big is the Arms Length PCB?

The Arms Length measures 35.6 × 59.8 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Arms Length?

5 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the Arms Length design files?

From the husnainxali/Arms_Length repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Arms Length design in my own project?

Yes, under the terms of its MIT license, which husnainxali chose for the repository.

Can I test firmware for the Arms Length without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

Similar boards