Allosaurus footprint interactive

iwonder77·allosaurus-footprint-interactive·hardware/stomp-pad-optoisolation-board/stomp-pad-optoisolation-board.kicad_pcb

Allosaurus footprint interactive PCB layout, top view — open source board by iwonder77

About the Allosaurus footprint interactive PCB

Allosaurus footprint interactive is an open source PCB design by iwonder77, published on GitHub. It is a 2-layer board measuring 40 × 45 mm, with 29 components from 9 distinct parts.

Other key parts include the H11L1. By type, the board carries 9 resistors, 6 diodes, 6 capacitors, 5 connectors and 3 ICs.

From the project

Three-channel, optically-isolated 24 V input board plus ESP32 show controller that turns industrial safety mats ("stomp pads") into clean, debounced triggers for synchronized video and LED strip output at the Need for Speed exhibit in Thanksgiving Point's Museum of Ancient Life.

Three-channel, optically-isolated 24 V input board plus ESP32 show controller that turns industrial safety mats ("stomp pads") into clean, debounced triggers for synchronized video and LED strip output at the Need for Speed exhibit in Thanksgiving Point's Museum of Ancient Life. A visitor stomps a footprint mat, and the matching dinosaur's clip plays with an accompanying light strip animation around that Allosaurus' femur bone cast.

Allosaurus footprint interactive, from the project README
From the project README

Main components on the Allosaurus footprint interactive

Allosaurus footprint interactive bill of materials (BOM)

29 components, 9 distinct parts.

QtyPartRefs
3
H11L1
U1, U2, U3
3
Conn_01x02_Pin
J1, J3, J4
1
Screw_Terminal_01x02
J2
1
Conn_01x05_Pin
J5
3
LED
D1, D3, D5
3
1N4148W
D2, D4, D6
6
0.1uF
C1, C2, C3, C4, C5, C6
6
1k
R1, R2, R4, R5, R7, R8
3
2.2k
R3, R6, R9

Allosaurus footprint interactive design files

The KiCad project lives in the iwonder77/allosaurus-footprint-interactive repository on GitHub; these links point at the commit this page was built from.

Allosaurus footprint interactive: common questions

How big is the Allosaurus footprint interactive PCB?

The Allosaurus footprint interactive measures 40 × 45 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Allosaurus footprint interactive?

29 components, from 9 distinct parts. The full bill of materials is listed on this page.

Where can I download the Allosaurus footprint interactive design files?

From the iwonder77/allosaurus-footprint-interactive repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Allosaurus footprint interactive design in my own project?

The repository has no license, so all rights stay with iwonder77. Use it as a reference, and ask the author before reusing the design.