STM32F4Example

JAS-UCF·KICAD-Workshop·STM32F4Example/STM32F4Example.kicad_pcb

STM32F4Example PCB layout, top view — open source STM32 board by JAS-UCF

About the STM32F4Example PCB

STM32F4Example is an open source STM32 PCB design by JAS-UCF, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 27 × 44.7 mm, with 24 components from 13 distinct parts.

Its main chip is the STM32F411CCUx, from the STM32 family. Other key parts include the AZ1117H-3.3TRG1 and GT-USB-7010ASV. By type, the board carries 13 capacitors, 3 ICs, 3 connectors, 3 resistors, 1 crystal and 1 inductor.

From the project

This project contains EVERY KiCAD example from workshops

The folders in here are the JAS -KiCAD Workshop files for a basic template, the example goes through component selection & wiring

Main components on the STM32F4Example

STM32F4Example bill of materials (BOM)

24 components, 13 distinct parts.

QtyPartRefs
1
AZ1117H-3.3TRG1
U2
1
GT-USB-7010ASV
U3
1
STM32F411CCUx
U4
1
X322512MSB4SI
X1
1
Conn_01x02_Pin
J1
2
Conn_01x17_Pin
J2, J3
1
10uH
L1
7
100nF
C1, C2, C3, C4, C5, C6, C7
2
13pF
C8, C9
3
10uF
C10, C11, C12
1
4.7uF
C13
2
5K1
R1, R3
1
10K
R2

STM32F4Example design files

The KiCad project lives in the JAS-UCF/KICAD-Workshop repository on GitHub; these links point at the commit this page was built from.

STM32F4Example: common questions

What microcontroller does the STM32F4Example use?

The STM32F4Example is built around the STM32F411CCUx, from the STM32 family.

How big is the STM32F4Example PCB?

The STM32F4Example measures 27 × 44.7 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the STM32F4Example?

24 components, from 13 distinct parts. The full bill of materials is listed on this page.

Where can I download the STM32F4Example design files?

From the JAS-UCF/KICAD-Workshop repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the STM32F4Example design in my own project?

Yes, under the terms of its GPL-3.0 license, which JAS-UCF chose for the repository.

Can I test firmware for the STM32F4Example without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

More boards in KICAD-Workshop

Similar boards