Fat8

jkearneyma·fat8·hardware/fat8.kicad_pcb

Fat8 PCB layout, top view — open source board by jkearneyma

About the Fat8 PCB

Fat8 is an open source PCB design by jkearneyma, published on GitHub under the BSD-3-Clause license. It is a 2-layer board measuring 75 × 45 mm, with 22 components from 15 distinct parts.

Other key parts include the C8008, FM1808B-SG, ATF1504ASL-25AU100 and MCP2221AxSL. By type, the board carries 8 capacitors, 4 ICs, 4 resistors, 3 connectors, 1 switch and 1 diode.

From the project

Physically tiny, but fat in capability Intel 8008 SBC

The hardware is physically quite minimal but is still "discrete" in the sense that the 8008 CPU is supported by gate-level logic and an actual memory IC, not a microcontroller or FPGA pretending to be logic or memory. The highest integration chip is actually the USB interface, which is actually an embedded PIC processor. The only thing that device does is provide a clock signal and a TTL serial connection, however.

Main components on the Fat8

C8008FM1808B-SGATF1504ASL-25AU100MCP2221AxSL

Fat8 bill of materials (BOM)

22 components, 15 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
C8008
U1
1
FM1808B-SG
U2
1
ATF1504ASL-25AU100
U4
1
MCP2221AxSL
U5
1
Conn_ARM_JTAG_SWD_10
J1
1
USB_B_Micro
J2
1
Conn_02x10_Row_Letter_First
J3
1
DCP020509U
DC1
1
KMR241GLFS
SW1
1
LED
D1
6
0.1
C1, C2, C3, C4, C5, C6
1
1.0
C7
1
2.2 low ESR
C8
1
1.0K
1K
R1
3
10K
R2, R3, R4

Fat8 design files

The KiCad project lives in the jkearneyma/fat8 repository on GitHub; these links point at the commit this page was built from.

Fat8: common questions

How big is the Fat8 PCB?

The Fat8 measures 75 × 45 mm, has 2 copper layers and is 1.600198 mm thick.

How many components are on the Fat8?

22 components, from 15 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Fat8 design files?

From the jkearneyma/fat8 repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Fat8 design in my own project?

Yes, under the terms of its BSD-3-Clause license, which jkearneyma chose for the repository.