Europa

Kazma1-1·Europa·Europa-Hardware/Europa.kicad_pcb

Europa PCB layout, top view — open source STM32 board by Kazma1-1

About the Europa PCB

Europa is an open source STM32 PCB design by Kazma1-1, published on GitHub under the BSD-3-Clause license. It is a 4-layer board measuring 40 × 40 mm, with 32 components from 26 distinct parts.

Its main chip is the STM32F030F4PX, from the STM32 family. Other key parts include the AMS1117-3.3. By type, the board carries 9 capacitors, 9 resistors, 4 connectors, 3 diodes, 2 ICs and 1 transistor.

Main components on the Europa

Europa bill of materials (BOM)

32 components, 26 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32F030F4PX
STM32F030F4Px
U1
1
AMS1117-3.3
U2
1
AO3401A
Q1
1
16MHZ
16MHz
Y1
1
PWR
J1
1
I2C1
J2
1
SWD
J3
1
USART1
J4
1
1A/33V
F1
1
BOOT
SW1
1
C72043
Green
D3
1
C72038
Yellow
D4
1
LED_RGBA
D5
1
100@100MHz
FB1
1
4u7
C1
1
100n
C2
1
4U7
6p
C3
1
100N
6p
C4
1
1u
C5
1
100N
100n
C6
Show 6 more
QtyPartRefs
2
10U
10u
C7, C8
1
10N
10n
C12
1
0
R2
2
4K7
4k7
R3, R6
5
1K5
1k5
R7, R8, R9, R10, R11
1
10K
10k
R12

Europa design files

The KiCad project lives in the Kazma1-1/Europa repository on GitHub; these links point at the commit this page was built from.

Europa: common questions

What microcontroller does the Europa use?

The Europa is built around the STM32F030F4PX, from the STM32 family.

How big is the Europa PCB?

The Europa measures 40 × 40 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Europa?

32 components, from 26 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Europa design files?

From the Kazma1-1/Europa repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Europa design in my own project?

Yes, under the terms of its BSD-3-Clause license, which Kazma1-1 chose for the repository.

Can I test firmware for the Europa without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards