TempControlBox

lologog·TempControlBox·PCB/PID_TEMPERATURE_KICAD.kicad_pcb

TempControlBox PCB layout, top view — open source STM32 board by lologog

About the TempControlBox PCB

TempControlBox is an open source STM32 PCB design by lologog, published on GitHub under the MIT license. It is a 2-layer board measuring 160 × 102 mm, with 60 components from 29 distinct parts.

Its main chip is the STM32F103C8Tx, from the STM32 family. By type, the board carries 20 resistors, 14 capacitors, 10 connectors, 4 diodes, 3 transistors and 1 IC.

It belongs with the sensors designs in this gallery.

From the project

Device for testing control algorithms and system identification

TempControlBox, from the project README
From the project README

Main components on the TempControlBox

TempControlBox bill of materials (BOM)

60 components, 29 distinct parts.

QtyPartRefs
1
STM32F103C8Tx
U1
3
MMBT2222ALT3G
Q1, Q2, Q3
1
EXT_Supply
J1
1
LCD 1602 2.54mm
J2
3
Screw_Terminal_01x05
J3, J5, J6
1
FAN
J4
1
BUTTON_2
J11
1
BUTTON_1
J12
1
Keyboard1
J13
1
Keyboard2
J14
1
~
BMP1
1
Buzzer
BZ1
1
~
ESP8266+NodeMCUv1
1
AGND <-> GND
JP1
1
~
SC189Z1
1
~
ST-Link-V3-Minie1
1
SW_Push
SW1
1
GREEN
D1
2
YELLOW
D2, D3
1
RED
D4
Show 9 more
QtyPartRefs
1
1 uH
L1
1
10 UF
C1
11
100n
C2, C3, C4, C5, C6, C7, C8, C9 +3
1
22 uF
C14
1
10u
C16
4
330
R2, R3, R4, R5
14
1k
R6, R7, R8, R10, R11, R12, R13, R14 +6
1
100
R9
1
100k
R21

TempControlBox design files

The KiCad project lives in the lologog/TempControlBox repository on GitHub; these links point at the commit this page was built from.

TempControlBox: common questions

What microcontroller does the TempControlBox use?

The TempControlBox is built around the STM32F103C8Tx, from the STM32 family.

How big is the TempControlBox PCB?

The TempControlBox measures 160 × 102 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the TempControlBox?

60 components, from 29 distinct parts. The full bill of materials is listed on this page.

Where can I download the TempControlBox design files?

From the lologog/TempControlBox repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the TempControlBox design in my own project?

Yes, under the terms of its MIT license, which lologog chose for the repository.

Can I test firmware for the TempControlBox without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards