Mains monitor device

mains-monitor·mains-monitor-device

Mains monitor device PCB layout, top view — open source board by mains-monitor

About the Mains monitor device PCB

Mains monitor device is an open source PCB design by mains-monitor, published on GitHub under the MIT license. It is a 4-layer board measuring 52.2 × 30.8 mm, with 41 components from 19 distinct parts.

Other key parts include the XC6206P332PR-G, TP4065-4.2V-SOT25-R and NE555D. By type, the board carries 17 resistors, 12 capacitors, 5 ICs, 4 diodes and 2 transistors.

From the project

Mains Monitor Device

The device monitors a presence of mains voltage and sends notifications to the Backend when it turns on or off. It uses ESP32-C3 MCU as a core component. It implements the logic of the device and connects it to the outer world via Wi-Fi.

The device powers from 5V DC via micro-USB connector and from 3.7V 1000 mAh Li-Po battery, when mains is not available. Most of the time the device stays in deep sleep mode, so it consumes micro Amps. It wakes up for 20 sec when 5V DC power source becomes available or turns off just for sending a notification to the Backend, then goes to deep sleep again.…

Mains monitor device, from the project README
From the project README

Main components on the Mains monitor device

XC6206P332PR-GTP4065-4.2V-SOT25-RNE555D

Mains monitor device bill of materials (BOM)

41 components, 19 distinct parts — part numbers from the project's BOM.

QtyPartRefs
3
XC6206P332PR-G
U1, U4, U5
1
TP4065-4.2V-SOT25-R
U2
1
NE555D
U3
2
IRLML2402
Q1, Q2
1
C404969
MICROXNJ
USB1
1
C2286
LED-Blue
D1
2
MBR0520LT1
D2, D3
1
C2290
STATUS
D4
2
0.1U
0.1u
C1, C9
2
10U
10u
C2, C4
1
100N
100n
C3
5
1u
C5, C6, C7, C11, C12
1
10U
10u
C8
1
4.7U
4.7u
C10
5
10K
10k
R1, R2, R3, R7, R9
2
3k
R4, R8
2
5k
R5, R6
5
100
R10, R11, R12, R18, R19
3
100K
100k
R13, R16, R17

Mains monitor device design files

The KiCad project lives in the mains-monitor/mains-monitor-device repository on GitHub; these links point at the commit this page was built from.

Mains monitor device: common questions

How big is the Mains monitor device PCB?

The Mains monitor device measures 52.2 × 30.8 mm, has 4 copper layers and is 1.6 mm thick.

How many components are on the Mains monitor device?

41 components, from 19 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Mains monitor device design files?

From the mains-monitor/mains-monitor-device repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Mains monitor device design in my own project?

Yes, under the terms of its MIT license, which mains-monitor chose for the repository.