Getting to blinky with
mez·getting_to_blinky_with_kicad
About the Getting to blinky with PCB
Getting to blinky with is an open source PCB design by mez, published on GitHub under the MIT license. It is a 2-layer board measuring 33 × 30.5 mm, with 7 components from 6 distinct parts.
Other key parts include the 7555. By type, the board carries 3 resistors, 1 IC, 1 battery holder, 1 diode and 1 capacitor.
From the project
Learning the pipeline of creating a PCB from scratch. From ground zero design using Kicad, to ordering the PCB, and finally using SMD soldering to put it together.
Learning the pipeline of creating a PCB (printed circuit board) from scratch. From ground zero design using Kicad, to ordering the PCB via OSHPark, and finally using SMD soldering to put it together. This project is building flashing LED circuit using a 7555 CMOS timer.
This started because I tried to build an open source hardware device called the CANtact. I wanted to make my own CAN sniffer so that I could look into decoding CAN messages. The CANtact hooks into your car via an OBD2 wire and connects to a computer via USB... Long story short I bit off more than I could chew; I never…

Main components on the Getting to blinky with
Getting to blinky with bill of materials (BOM)
7 components, 6 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | 7555 | SOIC-8_3.9x4.9mm_Pitch1.27mm | U1 |
| 1 | Battery | S8211R | BT1 |
| 1 | LED | LED_0805 | D1 |
| 1 | 1UF | C_0805_HandSoldering | C1 |
| 2 | 1K | R_0805_HandSoldering | R1, R3 |
| 1 | 470K | R_0805_HandSoldering | R2 |
Getting to blinky with design files
The KiCad project lives in the mez/getting_to_blinky_with_kicad repository on GitHub; these links point at the commit this page was built from.
Getting to blinky with: common questions
How big is the Getting to blinky with PCB?
The Getting to blinky with measures 33 × 30.5 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the Getting to blinky with?
7 components, from 6 distinct parts. The full bill of materials is listed on this page.
Where can I download the Getting to blinky with design files?
From the mez/getting_to_blinky_with_kicad repository on GitHub, which has the KiCad layout; the links under Design files point to each one.
Can I use the Getting to blinky with design in my own project?
Yes, under the terms of its MIT license, which mez chose for the repository.