HardLabs

Businesscard panelized

Miceuz·LEDCard

Businesscard panelized PCB layout, top view — open source AVR/Arduino board by Miceuz

About the Businesscard panelized PCB

Businesscard panelized is an open source AVR/Arduino PCB design by Miceuz, published on GitHub. It is a 2-layer board measuring 80 × 48 mm, with 32 components from 11 distinct parts.

Its main chip is the ATTINY44-S, from the AVR/Arduino family. By type, the board carries 18 diodes, 8 resistors, 2 capacitors, 1 IC, 1 transistor and 1 connector.

From the project

A business card with blinky leds

Main components on the Businesscard panelized

ATTINY44-S

Businesscard panelized bill of materials (BOM)

32 components, 11 distinct parts.

QtyPartRefs
1
ATTINY44-S
IC1
1
MOSFET_N
Q1
1
AVR-ISP-6
CON1
1
BATTERY
BT1
18
LED
D1, D2, D3, D4, D5, D6, D7, D8 +10
1
C
C1
1
C
C2
5
R
R1, R2, R3, R4, R5
1
10M
R6
1
680k
R7
1
10k
R8

Businesscard panelized design files

The KiCad project lives in the Miceuz/LEDCard repository on GitHub; these links point at the commit this page was built from.

Businesscard panelized: common questions

What microcontroller does the Businesscard panelized use?

The Businesscard panelized is built around the ATTINY44-S, from the AVR/Arduino family.

How big is the Businesscard panelized PCB?

The Businesscard panelized measures 80 × 48 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Businesscard panelized?

32 components, from 11 distinct parts. The full bill of materials is listed on this page.

Where can I download the Businesscard panelized design files?

From the Miceuz/LEDCard repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Businesscard panelized design in my own project?

The repository has no license, so all rights stay with Miceuz. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Businesscard panelized without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in LEDCard

Similar boards