Petstarbie

miyakostarry·petstarbie·hardware/starbie_pet/starbie_pet.kicad_pcb

Petstarbie PCB layout, top view — open source board by miyakostarry

About the Petstarbie PCB

Petstarbie is an open source PCB design by miyakostarry, published on GitHub. It is a 2-layer board measuring 67.1 × 95.4 mm, with 14 components from 9 distinct parts.

By type, the board carries 2 switches and 2 resistors.

It belongs with the power & battery, sensors and displays & leds designs in this gallery.

From the project

A small digital pet that lives inside a cat-shaped case. It shows a pet on a screen and reacts when you move it, press it's buttons or touch it.

A small digital pet that lives inside a cat-shaped case. It shows a pet on a screen and reacts when you move it, press it's buttons or touch it.

All the parts plug into sockets on a cat-shaped PCB (designed in KiCad). The board sits inside a 3D-printed cat shell.

- ESP32 DevKit V1 (30-pin) - 1.8" ST7735 SPI TFT display - MPU6050 (GY-521) gyro - DHT11 module - 2 tactile push buttons - 2 resistors, 100 kΩ - JST-PH battery connector - 3.7 V LiPo battery - TP4056 charger module - MT3608 boost converter

Petstarbie, from the project README
From the project README

Petstarbie bill of materials (BOM)

14 components, 9 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
Conn_01x03_Socket
DHT11temp1
2
CONN_01X08_SOCKET
Conn_01x08_Socket
GyroMPU6050, display1
2
CONN_01X02_SOCKET
Conn_01x02_Socket
Input1, Out1
1
SW_SPST
Powerswitch1
2
SW_Push
SW1, SW2
1
CONN_01X02_SOCKET
Conn_01x02_Socket
battery2
1
CONN_01X04_SOCKET
Conn_01x04_Socket
charging1
2
CONN_01X15_SOCKET
Conn_01x15_Socket
espleft1, espright1
2
R
R1batlvl1, R2batlvl1

Petstarbie design files

The KiCad project lives in the miyakostarry/petstarbie repository on GitHub; these links point at the commit this page was built from.

Petstarbie: common questions

How big is the Petstarbie PCB?

The Petstarbie measures 67.1 × 95.4 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Petstarbie?

14 components, from 9 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Petstarbie design files?

From the miyakostarry/petstarbie repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Petstarbie design in my own project?

The repository has no license, so all rights stay with miyakostarry. Use it as a reference, and ask the author before reusing the design.

Similar boards