HardLabs

Phoque-PowerShield

Moddingear·Phoque-PowerShield

Phoque-PowerShield PCB layout, top view — open source board by Moddingear

About the Phoque-PowerShield PCB

Phoque-PowerShield is an open source PCB design by Moddingear, published on GitHub under the Unlicense license. It is a 2-layer board measuring 50 × 50 mm, with 20 components from 3 distinct parts.

By type, the board carries 19 capacitors and 1 connector.

It belongs with the dev boards & breakouts designs in this gallery.

From the project

Shield to provide XT60 power connector, capacitors, and a brake resitor to Phoque-series of brushless drivers

This is an example shield for the Phoque-series of brushless drivers. Includes: - XT60 connector - 2.8Ohm configurable PCB resistor (can overheat, be careful, shouldn't be left on) - Extra capacitors (Recommend JIERR PA63V470M10X17 for the through-hole)

This shield can be connected to the main board using 4mm M3 brass standoffs.

Phoque-PowerShield bill of materials (BOM)

20 components, 3 distinct parts.

QtyPartRefs
1
XT60PW-M
J1
3
C_Polarized
C1, C2, C3
16
10u
C4, C5, C6, C7, C8, C9, C10, C11 +8

Phoque-PowerShield design files

The KiCad project lives in the Moddingear/Phoque-PowerShield repository on GitHub; these links point at the commit this page was built from.

Phoque-PowerShield: common questions

How big is the Phoque-PowerShield PCB?

The Phoque-PowerShield measures 50 × 50 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Phoque-PowerShield?

20 components, from 3 distinct parts. The full bill of materials is listed on this page.

Where can I download the Phoque-PowerShield design files?

From the Moddingear/Phoque-PowerShield repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Phoque-PowerShield design in my own project?

Yes, under the terms of its Unlicense license, which Moddingear chose for the repository.

Similar boards