Encoder board

molanocortes·takto-one·electronics/encoder_board/kicad/encoder_board.kicad_pcb

Encoder board layout, top view — open source board by molanocortes

About the Encoder board

Encoder board is an open source PCB design by molanocortes, published on GitHub under the Custom license license. It is a 2-layer board measuring 10.5 × 11.5 mm, with 3 components from 2 distinct parts.

Other key parts include the TCA9548APWR. By type, the board carries 2 capacitors and 1 IC.

It belongs with the robotics & motion and wearables designs in this gallery.

From the project

Open-source hand exoskeleton that reads twelve finger joints with magnetic encoders and drives them through tendons. Full build (TAKTO ONE) or sensing-only (TAKTO Lite). CAD, KiCad PCBs, Teensy firmware, live 3D twin in browser, phone and AR, BOM, EMG.

This folder contains the two custom PCB designs used by TAKTO ONE.

- encoderboard/ is the AS5600 magnetic encoder board. - palmcarrier/ is the palm sensor carrier and TCA9548A multiplexer board.

Each board includes its KiCad source and the matching manufacturing outputs. The checked-in sources match the working project copies used for this release.

The current embedded motor architecture uses a separate 74HC241 half-duplex interface on Teensy Serial1, with direction control on pin 7. That interface is not integrated into the published palm-carrier Gerbers. Do not infer motor-bus wiring…

Main components on the Encoder board

Encoder board bill of materials (BOM)

3 components, 2 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
TCA9548APWR
AS5600-ASOM
AMS
U1
2
100nF
C1, C2

Encoder board design files

The KiCad project lives in the molanocortes/takto-one repository on GitHub; these links point at the commit this page was built from.

Encoder board: common questions

How big is the Encoder board?

The Encoder board measures 10.5 × 11.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Encoder board?

3 components, from 2 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Encoder board design files?

From the molanocortes/takto-one repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Encoder board design in my own project?

It is published under Custom license, which limits how it may be reused; read the license before building on it.

More boards in takto-one

Similar boards