HardLabs

Layout-01

P-r-i-t-h-v-i·PCGE·challenges/layout-01/starter/layout-01.kicad_pcb

Layout-01 PCB layout, top view — open source AVR/Arduino board by P-r-i-t-h-v-i

About the Layout-01 PCB

Layout-01 is an open source AVR/Arduino PCB design by P-r-i-t-h-v-i, published on GitHub. It is a 2-layer board measuring 35 × 25 mm, with 4 components from 4 distinct parts.

Its main chip is the ATtiny85-20S, from the AVR/Arduino family. By type, the board carries 2 capacitors, 1 IC and 1 connector.

From the project

TraceWire: an OverTheWire-style wargame for learning PCB design by fixing broken KiCad projects (sandboxed kicad-cli ERC/DRC grading)

PCB Range challenge starter — layout-01 Open layout-01.kicadpro in KiCad 10 (or newer), fix the problem described on the challenge page, then zip this folder (layout-01.kicadpro, layout-01.kicadsch, layout-01.kicadpcb) and upload it.

Main components on the Layout-01

ATtiny85-20S

Layout-01 bill of materials (BOM)

4 components, 4 distinct parts.

QtyPartRefs
1
ATtiny85-20S
U1
1
3V3_IN
J1
1
100nF
C1
1
10uF
C2

Layout-01 design files

The KiCad project lives in the P-r-i-t-h-v-i/PCGE repository on GitHub; these links point at the commit this page was built from.

Layout-01: common questions

What microcontroller does the Layout-01 use?

The Layout-01 is built around the ATtiny85-20S, from the AVR/Arduino family.

How big is the Layout-01 PCB?

The Layout-01 measures 35 × 25 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Layout-01?

4 components, from 4 distinct parts. The full bill of materials is listed on this page.

Where can I download the Layout-01 design files?

From the P-r-i-t-h-v-i/PCGE repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.

Can I use the Layout-01 design in my own project?

The repository has no license, so all rights stay with P-r-i-t-h-v-i. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Layout-01 without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug AVR/Arduino firmware against it before you order a PCB.

More boards in PCGE

Similar boards