30 open source boards using the ATtiny85-20S

Real designs built with the ATtiny85-20S, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

30 boardsClear filters|Most starred

How designs wire the ATtiny85-20S

Read from the KiCad layouts of 25 open source designs, one per repository: what each pin of the ATtiny85-20S connects to, and the resistors, capacitors and other passives placed on it.

  • The VCC pin has a decoupling capacitor on 14 of 25 designs, most often 100 nF (then 10 µF).
XTAL2/PB4pin 3Connected to: A connector 40% · not connected 20%
  • Series resistor on 32% · 68 Ω (5), 66.5 Ω (2)
GNDpin 4Connected to: GND 92%
PB1pin 6Connected to: A connector 52% · not connected 16%
  • Series resistor on 32% · 330 Ω (3), 1 kΩ (2), 220 Ω (1)
PB2pin 7Connected to: A connector 48%
  • Series resistor on 32% · 1.5 kΩ (1), 66.5 Ω (1), 330 Ω (1)
VCCpin 8Connected to: 5V 84% · a signal 16%
  • Decoupling capacitor on 56% · 100 nF (7), 10 µF (4), 2.2 µF (1)

3 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include Strip dimmer by dennisss, Attiny85-testboard by cnlohr, START MODULE by bismarx-v1 and Attiny85-usb hid by 69series.

The ATtiny85-20S in open source designs

The gallery holds 30 open source boards using the ATtiny85-20S from 27 GitHub repositories; a typical one measures about 42.5 × 30 mm and carries around 13 components.

96% are two-layer designs, the rest use four layers or more, and 30% carry an open source license.

The most starred is Strip dimmer by dennisss.

Parts used alongside the ATtiny85-20S

Microcontrollers on boards using the ATtiny85-20S

ATtiny85-20S: common questions

Where can I find a ATtiny85-20S reference design?

Each of the 30 boards on this page is a real design using the ATtiny85-20S. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

What decoupling capacitors do designs use on the ATtiny85-20S VCC pin?

The VCC pin has a decoupling capacitor on 14 of 25 designs, most often 100 nF (then 10 µF). Counted from the KiCad layouts of 25 open source designs using the ATtiny85-20S.

Which microcontrollers do boards using the ATtiny85-20S use?

Most are built on AVR/Arduino (30).

How big is a typical board using the ATtiny85-20S?

The median is 42.5 × 30 mm, and 96% are two-layer designs.

What is the most popular open source board using the ATtiny85-20S?

By GitHub stars, Strip dimmer by dennisss, with 381 stars.

Can I simulate one of these boards using the ATtiny85-20S before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part