LoadCellAdapter
About the LoadCellAdapter PCB
LoadCellAdapter is an open source PCB design by ravinrabbid, published on GitHub under the MIT license. It is a 2-layer board measuring 17 × 32.5 mm, with 5 components from 5 distinct parts.
From the project
RP2040 based firmware and hardware for Dance Pad Controllers
A simple passive adapter pcb to combine four 3-Wire half bridge load cells into a Wheatstone bridge configuration.
LoadCellAdapter bill of materials (BOM)
5 components, 5 distinct parts.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | Out | JST_PH_S4B-PH-K_1x04_P2.00mm_Horizontal | J1 |
| 1 | Upper Left | JST_PH_S4B-PH-K_1x04_P2.00mm_Horizontal | J2 |
| 1 | Upper Right | JST_PH_S4B-PH-K_1x04_P2.00mm_Horizontal | J3 |
| 1 | Lower Left | JST_PH_S4B-PH-K_1x04_P2.00mm_Horizontal | J4 |
| 1 | Lower Right | JST_PH_S4B-PH-K_1x04_P2.00mm_Horizontal | J5 |
LoadCellAdapter design files
The KiCad project lives in the ravinrabbid/DanceCon2040 repository on GitHub; these links point at the commit this page was built from.
LoadCellAdapter: common questions
How big is the LoadCellAdapter PCB?
The LoadCellAdapter measures 17 × 32.5 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the LoadCellAdapter?
5 components, from 5 distinct parts. The full bill of materials is listed on this page.
Where can I download the LoadCellAdapter design files?
From the ravinrabbid/DanceCon2040 repository on GitHub, which has the KiCad layout and the schematic; the links under Design files point to each one.
Can I use the LoadCellAdapter design in my own project?
Yes, under the terms of its MIT license, which ravinrabbid chose for the repository.
