Schematic

robertrico·hardware·vintage/AT89S52/schematic/schematic.kicad_pcb

Schematic PCB layout, top view — open source board by robertrico

About the Schematic PCB

Schematic is an open source PCB design by robertrico, published on GitHub. It is a 2-layer board measuring 58 × 104 mm, with 17 components from 16 distinct parts.

Other key parts include the AT89S52. By type, the board carries 9 connectors, 4 capacitors, 1 IC, 1 crystal, 1 switch and 1 resistor.

It belongs with the iot & wireless and displays & leds designs in this gallery.

From the project

Personal embedded systems portfolio — circuits, firmware, and physical builds. Each project showcases a hardware concept, toolchain, or interface.

Welcome to my Embedded Systems Portfolio. This document introduces several projects, highlighting their objectives, technologies, and current status.

Objective: GPIO control demonstration using Zephyr RTOS. Technologies: Raspberry Pi Pico, Zephyr RTOS, DeviceTree. Current Status**: Complete.

Objective: Basic FreeRTOS demonstration with task scheduling and GPIO control. Technologies: FreeRTOS, Raspberry Pi Pico W, Pico W2, ESP32. Current Status**: Complete

Main components on the Schematic

Schematic bill of materials (BOM)

17 components, 16 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
AT89S52
U1
1
11.05920 MHz
Y1
1
P1
J1
1
P0
J2
1
P2
J3
1
P3
J4
1
ALE
J5
1
~{PSEN}
J6
1
USB_B_Micro
J7
1
GND
J8
1
VCC
J9
1
Reset
SW1
2
22PF
22pF
C1, C2
1
10µF
C3
1
0.1µF
C4
1
10kΩ
R1

Schematic design files

The KiCad project lives in the robertrico/hardware repository on GitHub; these links point at the commit this page was built from.

Schematic: common questions

How big is the Schematic PCB?

The Schematic measures 58 × 104 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Schematic?

17 components, from 16 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Schematic design files?

From the robertrico/hardware repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Schematic design in my own project?

The repository has no license, so all rights stay with robertrico. Use it as a reference, and ask the author before reusing the design.

More boards in hardware

Similar boards