PowerSupply GUI
SohCahNoah·PowerSupply_GUI·SensorBlock PCB Files/TempSensorBlock.kicad_pcb
About the PowerSupply GUI PCB
PowerSupply GUI is an open source PCB design by SohCahNoah, published on GitHub. It is a 2-layer board measuring 19 × 22 mm, with 7 components from 5 distinct parts.
Other key parts include the LM75B. By type, the board carries 3 resistors, 2 connectors, 1 IC and 1 capacitor.
From the project
Junior Design 2 - Project Group: EJ16 Project: DC-to-DC Power Supply with GUI interface
Junior Design 2 - Project Group: EJ16 Project: DC-to-DC Power Supply with GUI interface
Steps to operate: 1. Connect the Arduino Uno to the host computer 2. Upload the firmware to the Arduino 3. Ensure that the correct pins are connected to the system for I2C communication (SDK, SDA, 5V VCC, GND) 4. Close any active Serial communications with the Arduino (such as in the Arduino IDE) 5. Run the Python Code
Main components on the PowerSupply GUI
PowerSupply GUI bill of materials (BOM)
7 components, 5 distinct parts — part numbers from the project's BOM.
| Qty | Part | Footprint | Refs |
|---|---|---|---|
| 1 | LM75B | VSSOP-8_3.0x3.0mm_P0.65mm | U1 |
| 1 | Source Input (Screw) | TerminalBlock_TE_282834-2_1x02_P2.54mm_Horizontal | J1 |
| 1 | Microcontroller Terminal (Screw) | TerminalBlock_TE_282834-3_1x03_P2.54mm_Horizontal | J2 |
| 1 | 100NF 100nF | C_0201_0603Metric | C1 |
| 3 | 10K 10k | R_0805_2012Metric | R1, R2, R3 |
PowerSupply GUI design files
The KiCad project lives in the SohCahNoah/PowerSupply_GUI repository on GitHub; these links point at the commit this page was built from.
PowerSupply GUI: common questions
How big is the PowerSupply GUI PCB?
The PowerSupply GUI measures 19 × 22 mm, has 2 copper layers and is 1.6 mm thick.
How many components are on the PowerSupply GUI?
7 components, from 5 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.
Where can I download the PowerSupply GUI design files?
From the SohCahNoah/PowerSupply_GUI repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.
Can I use the PowerSupply GUI design in my own project?
The repository has no license, so all rights stay with SohCahNoah. Use it as a reference, and ask the author before reusing the design.