HardLabs

Bingo card-1a

strickyak·copico-bonobo·v3.1-centipede/bingo-card-1a/bingo-card-1a.kicad_pcb

Bingo card-1a PCB layout, top view — open source board by strickyak

About the Bingo card-1a PCB

Bingo card-1a is an open source PCB design by strickyak, published on GitHub under the MIT license. It is a 2-layer board measuring 66 × 61 mm, with 3 components from 1 distinct parts.

From the project

KICAD: Simple and cheap PI PICO cartridge for Coco; can spoonfeed to boot, and has Control & Data ports decoded.

The Centipede is an experimental Coco Cartridge that uses a RP2350B microcontroller connected directly to the Coco Cartridge Expansion bus.

My experimental device uses this RP2350B board, but any board that exposes nearly all 48 GPIOs should work:

https://github.com/jvanderberg/RP2350B-Dev-Board

These are the current GPIO pin assigments:

Bingo card-1a bill of materials (BOM)

3 components, 1 distinct parts — part numbers from the project's BOM.

QtyPartRefs
3
Conn_02x10_Odd_Even
J1, J2, J3

Bingo card-1a design files

The KiCad project lives in the strickyak/copico-bonobo repository on GitHub; these links point at the commit this page was built from.

Bingo card-1a: common questions

How big is the Bingo card-1a PCB?

The Bingo card-1a measures 66 × 61 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Bingo card-1a?

3 components, from 1 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Bingo card-1a design files?

From the strickyak/copico-bonobo repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Bingo card-1a design in my own project?

Yes, under the terms of its MIT license, which strickyak chose for the repository.

More boards in copico-bonobo