HardLabs

Spoon23d

strickyak·copico-bonobo·v2.3/spoon23d/spoon23d.kicad_pcb

Spoon23d PCB layout, top view — open source RP2040/RP2350 board by strickyak

About the Spoon23d PCB

Spoon23d is an open source RP2040/RP2350 PCB design by strickyak, published on GitHub under the MIT license. It is a 2-layer board measuring 100 × 96 mm, with 32 components from 12 distinct parts.

Its main chip is the PicoW, from the RP2040/RP2350 family. Other key parts include the C6818 and C7859. By type, the board carries 10 connectors, 10 capacitors, 8 ICs, 3 test points and 1 jumper.

From the project

KICAD: Simple and cheap PI PICO cartridge for Coco; can spoonfeed to boot, and has Control & Data ports decoded.

Main components on the Spoon23d

C6818PicoWC7859

Spoon23d bill of materials (BOM)

32 components, 12 distinct parts — part numbers from the project's BOM.

QtyPartRefs
4
C6818
74LS138
U1, U2, U3, U4
1
PicoW
U7
3
C7859
SN74LVC4245APWR
U8, U9, U10
4
Conn_01x08_Pin
J1, J2, J5, J6
2
Conn_01x04_Pin
J3, J4
1
CocoEdgeConnector
P1
1
Coco Data
P2
1
Coco Address
P3
1
Coco Signals
P4
1
SolderJumper_2_Bridged
JP1
3
TestPoint
TP1, TP3, TP4
10
C1525
C_Small
C1, C2, C3, C4, C5, C6, C7, C8 +2

Spoon23d design files

The KiCad project lives in the strickyak/copico-bonobo repository on GitHub; these links point at the commit this page was built from.

Spoon23d: common questions

What microcontroller does the Spoon23d use?

The Spoon23d is built around the PicoW, from the RP2040/RP2350 family.

How big is the Spoon23d PCB?

The Spoon23d measures 100 × 96 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Spoon23d?

32 components, from 12 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Spoon23d design files?

From the strickyak/copico-bonobo repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Spoon23d design in my own project?

Yes, under the terms of its MIT license, which strickyak chose for the repository.

Can I test firmware for the Spoon23d without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug RP2040/RP2350 firmware against it before you order a PCB.

More boards in copico-bonobo

Similar boards