Ergosnap

tcrs·ergosnap·pcb/ergosnap.kicad_pcb

Ergosnap PCB layout, top view — open source board by tcrs

About the Ergosnap PCB

Ergosnap is an open source PCB design by tcrs, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 140 × 135.5 mm, with 39 components from 5 distinct parts.

Other key parts include the ProMicro. By type, the board carries 34 switches, 2 connectors, 2 resistors and 1 IC.

It belongs with the keyboards designs in this gallery.

From the project

Keyboard based on the ErgoDash layout

WARNING. This is rev1.1, which works fine but has a few issues:

- The silkscreen for the ProMicro outline is incorrect for the USB-up placement - USB cable only just plugs into the ProMicro on the left half (plug shroud is against the edge of the PCB below the ProMicro) - SDA & SCL are the wrong way around on the 5pin header for the Pimoroni trackball breakout, so that doesn't work without some jumper wires...

Ergosnap, from the project README
From the project README

Main components on the Ergosnap

Ergosnap bill of materials (BOM)

39 components, 5 distinct parts.

QtyPartRefs
1
ProMicro
U3
1
Conn_01x05_Female
J0
1
5PIN
J1
34
switch_diode
SW1, SW2, SW3, SW4, SW5, SW6, SW7, SW8 +26
2
R
R1, R2

Ergosnap design files

The KiCad project lives in the tcrs/ergosnap repository on GitHub; these links point at the commit this page was built from.

Ergosnap: common questions

How big is the Ergosnap PCB?

The Ergosnap measures 140 × 135.5 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Ergosnap?

39 components, from 5 distinct parts. The full bill of materials is listed on this page.

Where can I download the Ergosnap design files?

From the tcrs/ergosnap repository on GitHub, which has the KiCad layout; the links under Design files point to each one.

Can I use the Ergosnap design in my own project?

Yes, under the terms of its GPL-3.0 license, which tcrs chose for the repository.

Similar boards