311 open source boards using the ProMicro

Real designs built with the ProMicro, from public GitHub projects: a quick way to see how others power, decouple and connect it. Each board comes with its KiCad files, full parts list and a render — and you can simulate its firmware on HardLabs.

311 boardsClear filters|Most starred

How designs wire the ProMicro

Read from the KiCad layouts of 205 open source designs, one per repository: what each pin of the ProMicro connects to, and the resistors, capacitors and other passives placed on it.

  • The RAW pin is left unconnected on 161 of 204 designs (VCC on 14, a signal on 29).
GNDpin 3, 4, 23Connected to: GND 82%
VCCpin 21Connected to: VCC 76%
RAWpin 24Connected to: Not connected 79%

19 more pins vary from design to design. Connections count pins, parts count designs; values in brackets are how many parts had that value. Designs read include SofleKeyboard by josefadamcik, Lily58 by kata0510, Ferris Sweep Compact by davidphilipbarr and Redox keyboard by mattdibi.

The ProMicro in open source designs

The gallery holds 311 open source boards using the ProMicro from 208 GitHub repositories; a typical one measures about 141 × 98.5 mm and carries around 77 components.

99% are two-layer designs, the rest use four layers or more, and 55% carry an open source license.

The most starred is SofleKeyboard by josefadamcik.

Microcontrollers on boards using the ProMicro

ProMicro: common questions

Where can I find a ProMicro reference design?

Each of the 311 boards on this page is a real design using the ProMicro. Open one to see how it is wired up, with the full BOM, a render of the layout and links to its KiCad files.

How is the ProMicro RAW pin connected?

The RAW pin is left unconnected on 161 of 204 designs (VCC on 14, a signal on 29). Counted from the KiCad layouts of 205 open source designs using the ProMicro.

What parts are used alongside the ProMicro?

The TRRS, SSD1306, 74HC138, CD74HC4067M and HOLE appear in the most repositories here.

Which microcontrollers do boards using the ProMicro use?

Most are built on AVR/Arduino (79) and RP2040/RP2350 (2).

How big is a typical board using the ProMicro?

The median is 141 × 98.5 mm, and 99% are two-layer designs.

What is the most popular open source board using the ProMicro?

By GitHub stars, SofleKeyboard by josefadamcik, with 2,546 stars.

Can I simulate one of these boards using the ProMicro before building it?

Yes. HardLabs turns a board's netlist and BOM into a working simulation, so you can boot and test firmware against it with no hardware on your desk.

Browse boards by part