Mechpad

techinc·mechpad·pcb/pcb.kicad_pcb

Mechpad PCB layout, top view — open source STM32 board by techinc

About the Mechpad PCB

Mechpad is an open source STM32 PCB design by techinc, published on GitHub. It is a 2-layer board measuring 100 × 100 mm, with 83 components from 16 distinct parts.

Its main chip is the STM32F072C8Tx, from the STM32 family. Other key parts include the AP2112K-3.3 and USBLC6-2SC6. By type, the board carries 32 diodes, 21 capacitors, 17 switches, 6 resistors, 4 connectors and 3 ICs.

From the project

mechanical keypad

Mechpad, from the project README
From the project README

Main components on the Mechpad

Mechpad bill of materials (BOM)

83 components, 16 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
STM32F072C8Tx
U1
1
AP2112K-3.3
U2
1
USBLC6-2SC6
U3
1
USB_C_Receptacle_USB2.0
J1
2
Conn_01x03_Male
J2, J4
1
Conn_01x04_Male
J3
1
SW_SPST
SW1
16
SW_Push_45deg
SW2, SW3, SW4, SW5, SW6, SW7, SW8, SW9 +8
16
C2890037
SK6812SIDE-A
D1, D2, D3, D4, D21, D22, D23, D24 +8
16
D_Schottky
D5, D6, D7, D8, D9, D10, D11, D12 +8
2
1uF
C1, C3
16
100NF
100nF
C2, C5, C7, C11, C12, C13, C14, C15 +8
3
100nF
C8, C9, C10
2
100k
R1, R2
2
5k1
R4, R5
2
22 Ohm
R6, R7

Mechpad design files

The KiCad project lives in the techinc/mechpad repository on GitHub; these links point at the commit this page was built from.

Mechpad: common questions

What microcontroller does the Mechpad use?

The Mechpad is built around the STM32F072C8Tx, from the STM32 family.

How big is the Mechpad PCB?

The Mechpad measures 100 × 100 mm, has 2 copper layers and is 1 mm thick.

How many components are on the Mechpad?

83 components, from 16 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Mechpad design files?

From the techinc/mechpad repository on GitHub, which has the KiCad layout and the BOM; the links under Design files point to each one.

Can I use the Mechpad design in my own project?

The repository has no license, so all rights stay with techinc. Use it as a reference, and ask the author before reusing the design.

Can I test firmware for the Mechpad without the hardware?

Yes. HardLabs builds a simulation of the board from its netlist and BOM, so you can run and debug STM32 firmware against it before you order a PCB.

Similar boards