Supercapacitor Bank v1

Thornbots·Supa-Cap·Design Files/Cap Bank V1/Passive Cap Bank V1.kicad_pcb

Supercapacitor Bank v1 PCB layout, top view — open source board by Thornbots

About the Supercapacitor Bank v1 PCB

Supercapacitor Bank v1 is an open source PCB design by Thornbots, published on GitHub under the GPL-3.0 license. It is a 2-layer board measuring 75 × 125 mm, with 29 components from 12 distinct parts.

By type, the board carries 14 resistors, 6 transistors, 6 capacitors, 1 connector, 1 switch and 1 diode.

From the project

Rose-Hulman's Thornbot's Electrical Team's Super Capacitor Bank

Rose-Hulman's Thornbot's Electrical Team's Super Capacitor Bank

This is an active, work in progress super capacitor bank and super capacitor controller board design that is intended to be used with the DJI Robomaster's competetion.

User Guide (Currently non-existent, but will be completed eventually) can be found in Documentation PCB Files can be found in the Design Files folder, with all of the projects being done in KiCAD 8.0.

Supercapacitor Bank v1 bill of materials (BOM)

29 components, 12 distinct parts — part numbers from the project's BOM.

QtyPartRefs
1
LMG5200
BC817-40
Q1
5
BC817-40
Q2, Q3, Q4, Q5, Q6
1
XT30PW-F
XT30-Male
J1
1
SW_Push_Open
SW1
1
10mm_LED
D1
1
10U
100F
C1
2
0.1U
100F
C2, C3
3
100F
C4, C5, C6
6
20k
R1, R3, R5, R7, R9, R11
6
7.87k
R2, R4, R6, R8, R10, R12
1
2 : 100Watt
R13
1
680
R14

Supercapacitor Bank v1 design files

The KiCad project lives in the Thornbots/Supa-Cap repository on GitHub; these links point at the commit this page was built from.

Supercapacitor Bank v1: common questions

How big is the Supercapacitor Bank v1 PCB?

The Supercapacitor Bank v1 measures 75 × 125 mm, has 2 copper layers and is 1.6 mm thick.

How many components are on the Supercapacitor Bank v1?

29 components, from 12 distinct parts, with part numbers taken from the project's own BOM. The full bill of materials is listed on this page.

Where can I download the Supercapacitor Bank v1 design files?

From the Thornbots/Supa-Cap repository on GitHub, which has the KiCad layout, the schematic and the BOM; the links under Design files point to each one.

Can I use the Supercapacitor Bank v1 design in my own project?

Yes, under the terms of its GPL-3.0 license, which Thornbots chose for the repository.

More boards in Supa-Cap